Blinking A/C light?

I have a 2015 Tacoma. I am in NC and lately while running my heat in the typical February cold, I noticed my A/C light blinking on and off between my fan dial and the heat/air dial. The A/C isn't on, but when I push the button 2 times, the light is on then goes off on the second push. Im trying to upload a video, but it isn't working. I took a screenshot of the video with the amber light blinking, then it goes off.

Is it a warning light? Anyone know what's happening?

 

The flashing A/C light is when the A/C amplifier does not detect a speed signal from the compressor lock sensor after commanding the MG CLT relay on.

Possible causes are:
Open or shorted wire(s) in the lock sensor circuit
Bad lock sensor
Internal problem in the compressor
Open or shorted wire(s) to the MG CLT relay
Open in the wire from the MG CLT relay to the compressor
Failed compressor clutch
Belt slipping
Failed A/C amplifier


Does the A/C Compressor turn on for a few seconds and then turn off when you press the A/C button or does it not turn on at all?

 

I am not hearing the compressor come on at all. I push the button for the light to stay on then push it again to turn it off and stop blinking. I will give it a try again today.

 

Do you have a test light?

If so we should be able to narrow this down pretty quick, test light connected to battery Ground check for power on Pin 2 & 5 of the MG CLT Relay with the key on.
Then test light connected to battery Positive check Pin 3, it should light up if the wire is continuous to the clutch coil and the coil windings are good.

If that all tests good then with the light still connected to battery Positive start the truck and have an assistant hit the A/C button while you hold the light on Pin 1 of the MG CLT Relay, it should light up briefly until the light starts flashing.