3rd Gen Owners with King Coilovers

IMO I would get UCA’s will help get alignment perfect depending on tech

 

With these 1.5-3 lift shocks does the bump stop need to be moved up a little?
I’m right at 1.5 inches of lift in the rear with icon RXT stage 1 with my steel bumper have a u bolt flip with super bumps waiting to go on.
Just not sure what route to go with the shocks since it’s either 0-1.5 or 1.5-3 and I’m right at that 1.5 mark

prob a dumb question but these shocks aren’t cheap

 

https://accutuneoffroad.com/product/accutune-offroad-u-bolt-flip-bump-stop-kit-05-23-toyota-tacoma-revised/

Check this out

 

100% agree, good quality stuff aint cheap. If you went with the 1.5-3" rear shocks, we would recommend our 1.75" inch spacer which can be accomplished using our "one size fits all" u-bolt flip & bump stop kit. Its hard to compare ours to other kits, since we account for the foam bump stop being able to be compressed almost all the way. Other brands unfortunately don't list their bump stop compressed lengths. Stock rubber for example, hardly budge at all creating a harsh bottom out. You may need to do some measuring to see how your bump stops compare to our chart.

 

Looking at the EXT fronts, does anyone know what the preset factory lift is? Would like to get around 1.7" of lift and trying to see if I can run these out of box or have to take into account taking it into a shop to get them adjusted

 

You can easily adjust them yourself and play with the settings to get exactly what you’re after

 

I would stick to the specs King or a good off-road shop recommend. Following top hat to center bolt at ride height etc.

 

For those running a 2” front lift. About how much threads do you have exposed? I am running 600lb springs. No bumper, just sliders and a front skid plate. I understand every setup is different, just trying to get an idea when I start adjusting preload.

 

Measure your top hat to center bolt King Spec sheet says to keep it at 21” at ride height. I’m at 20.5. Take a Hub to fender measurement https://accutuneoffroad.com/articles/preload-adjustments-on-oem-fit-coilovers/

 

Trying to refit my shocks after a rebuild and installing king’s shaft guards on the rears. The guard doesn’t fit on the driver side…that is if you want to run it facing forward…it contacts the axle. Running it backwards seems pointless. I’ll probably scrap these and find a universal guard kit. The only other solution I can think of is heating the plastic and trying to reshape it a bit.

Anyone else using these have a similar issue?