1st Gen Lunchtable Thread - General Discussion

Apparently the welds are good too

 

ya im tired yall lol

too much to mentally or emotionally process so im cranking the tunes and faking it through

 

it has been a few years so they have got some good practice in, they should be better lol

 

They finally hit double digit age and their primary motor cortex is developing

 

and someone from a different team “had a question “ but it was really just a trojan horse for 10 minutes of telling me Im bad at my job because i asked him not to break some code i wrote. lmao

 

like i dont even disagree about any of it except the urgency and refusal to just not break it lol

 

Questions with that sort of pretense are among the cardinal sins of communication in my opinion. Just get to the damn point.

 

This has to has to be a generational thing - I don't like beating around the bush but the younger crowd certainly does

 

hes your age, at a minimum

 

Damn he sounds old

 

there were in fact 0 questions and just a lecture

he was right about everything. i had no disagreement BUT the way it was broached

 

im putting this on your permanent record

 

Oooof

Probably the youngest child if he's acting like that though

 

yea. im just the latest victim, i guess according to some of my other coworkers he is known to do this lol

 

I hate getting guys like that on job sites. I know what my scope is. So when something outside of that needs done then tell me whos doing it or do i need to just right an RFI and issue a change order so im not doing it for free. Or if it is actually my scope show me in the drawing where it says that and I’ll do it

 

While screwing around with the spindles, one of them was looking a bit 'off' at the UBJ ring
Decided to take an angle finder to it to see if it matches... Is this a problem which requires attention?

The one that looked fine is on the right, measured 88d from the spindle vertical
The off one measured 84.7d. Zero-ed individually for each spindle ofc. The bent probably doesn't really register in this first picture, but its just barely noticeable when you're looking at it in person

 

I feel like cast doesn't really bend that great

 

Pretty sure they're forged, which can be bent?

 

Shows what I know

definitely have seen some pictures have the UBJ cup breaking

 

1st gen spindles can definitely bend lol