New England Mod & Meetup Thread: May 17 at Jared’s!!

I am having a hard time with that 2nd word, I though an Engineer was someone who ran a train.

 

Is the quiz open book?

 

Cope pulled me over and told me that as a joke

 

It can be. It will be 10 questions long.

 

This is all you need. Run how many wires into the cab depending on how many relays you have. 3 relays, 3 wires.
It would be best to supply the switch with ignition or accessory so you don't accidently kill the battery. The extra ground wire is not needed.

 

We arent doin april 5 anymore. Bens work decided to send him away on a work trip. Doing April 11 now.

 

I told you it was quick and dirty. I forgot the fuses.
For the supply for the switch, 5A should do it. For the other fuse, you will have to see how many watts your light draws.

 

Getting ready to add some leaf shims and noticed a missing bump stop, took zero effort to remove the other. Both sides rusted to hell.
Got the shims in and I’ll be gentle until I decide. If y’all see any deals let me know please.


Pics are in reverse order..

 

Thanks for the heads up. Yeah I’ll be out of town but I’m sure it’ll be a good time

 

Should have bought it, my floor jack no longer will work after the lift. Found this out yesterday when I went and checked bolts from the lift install. Found this will doing the check.

 

Like for finding it and unlike for the missing nut. Good thing you looked.

 

Congrats. We have 3 girls, 2 are adults now. It's been a wild ride...lol.

And this is what happens when I take a break from being online... I missed out. Again.

 

Only got 2 pics all day but we got it all done and had a good time. Don’t think anyone even bled. Was a great time with @jpereira2 and @InCogNeatOh Parts. Can’t wait for the first one of the year at @crashngiggles
May have set a personnel record on rags and gloves used, thanks woolwax!

 

I'm still using rags after getting home lol! Thank you again!! Can't thank yall enough. About to schedule my alignment tomorrow. Also it's a good thing you didn't take too many pics because of how ripped my pants were lol. Got home and my son was like look at the back!

 

I shoulda skipped skiing and seen you guys. Just got covered in ice. So much for 4" of fresh snow at Cannon

 

@AllTacosFloat
Did you ever find out what that "weightless" powder was?

 

For some reason this song came to mind after reading this post.
https://youtu.be/0hh974VZjNs?si=4dyRKuRQMJyfO76x

 

Well, we arent dead yet. Cant be that bad

 

So the clunk noise could be CV axle.

What are folks thoughts on replacing the CV, is there a better than factory replacement? for a 2.5 to 3 inch lift does it, should I look at a longer CV?

It was suggested NAPA lifetime is a good option.