Let's see your 1st Gen switch setups!

Has anyone come across a volt meter or trans temp gauge that would fit in a paranoid fab bracket?

 

https://rubyoffroad.com/ uses the factory ash tray for 1st Gen Tacoma and 3rd Gen 4Runners mainly for auxbeam but he can make custom ones if you can provide dimensions. Had a custom one made for my Vosswitch overall super happy with the location and build quality and material. You can use my discount code “Ruleteando” at check out for a discount on your order.

 

That's incredibly clean.

 

No drilling suction cups or double side tape used factory location easy install. 10/10 would recommend

 

For the upper switches left to right. They look pink when parking lights are on and illuminate red when activated

1. Fogs
2. Dual function reverse in rear bumper: up on with reverse, center off, down constant on
3. Dual function light bar on bumper: up white, center off, down amber
4. Rock lights

I like my double din stereo, biggest deterrent from putting switches under the stock stereo, that and I like everything in one place and on the same hand controlling high beams. If I add a front locker I might move the dual battery switch to the clock, or might go away from the Blue Sea setup and go for a BCDC charger.

Getting my wedge camper installed Monday after a 10 month wait any switches for outdoor floods, etc will go in there.

 

That’s a great use of space

 

Light bar and ditch lights. Simple clean set up. Need to get some updated charging ability for

 

This blows all the other ash tray switch panels out of the water wow. I know what I'm getting soon

 

What type of tool are you guys using to cut rectangle cut outs into the dash?
I need to mount my switches and wasn't sure the best way to do this.

 

Dremel with a plastic cut-off wheel.

 

Paranoid Fab custom switchpros ashtray mount

 

What head unit is that with that much tilt?

 

Kenwood Excelon DMX957XR at full tilt