What have you done to your Tacoma today? 1st Gen Edition

get a longer breaker bar.

 

im gonna have to try that. it's hard trying to hold both ends at the same time, while trying to break the nut loose

 

I hear ya, just make sure the socket is all the way on the nut before cranking on it or you're going to round it off. Maybe get someone to hold it on there for you?

 

Use more leverage (like what stevo said) or just more elbow grease... It took me a while to get those babies off too.

 

ya im trying to get a hold of a local TW member... other than that no one is around.. considering it is a tuesday afternoon

 

in the rear i went with a used AAL, toytech 2" shackles, and bilstein 5150's. 8.5 inch stroke

 

Used the scrap LEDs from the floor lighting mod. Wired to the same circuit

 

finished and installed this on the GF's truck.

A hoop and lights will be added to the bumper still, and Sliders are coming next.

 

New tint

 

somethings missing.....

 

sexy... what % is that? looks pretty dark

edit: I'm guessing 5%

 

my dash board lights and fog lights just stopped working when i put an LED bulb in the fog light. what should i check to see where the problem is?

 

20%

Looks darker because of the lighting probably... I love it.

 

That looks great, man! Wanna be my boyfriend? (no homo!) haha Seriously though, you're girlfriend is a lucky lady!

 

Nice! That looks sweet!


Received my Hella's in the mail today. Installed them pretty quick!

 

i got a dent in the same spot! Slid off a trail into some pine tree's lol

 

replaced my belts, a loose ground for the radio.


also PO jb welded in the corner lights like a retard and put a screw through my cb antenna cable.

 

at least yours was self inflicted. i wouldnt be so mad if i did it haha but no some asshole hit me and left

 

One of my low beams went out after putting led's in my dash, and a climate control bulb decides when it wants to be on or not now lol. Idk watsup.

 

Took struts out and gave them to a tire shop down the road. Asked them to remove the retarded spacers and keep the 5100s at the middle setting. Also have 2 new top plates that they will switch out the old ones with. Will post pics tomorrow once i get my struts back and reinstalled!

Also, how do you replace the speedometer lights to LED? I think a blue back glow would look pretty sweet. Is it straight forward to figure out? Or a PITA?