What Have You Done To Your 4th Gen Today?

Their*

affects*

if people are going to post, please respect my ocd and spell the words correctly

 

Yeah, my bad. I actually did this while driving. Shame on me. I am usually pretty good at my grammar. I laughed at you're reply. (yes I know it is your)

 

You have to expand the predrilled holes that are currently used by push clips to secure the plastic trim pieces.

 

"Their" not "there"...we all have different types of OCD...

 

Looks correct to me.

If people are going to post, please respect my ocd and use the correct word (their), capitalize the first letter of the first word in a sentence (If), and end your sentence(s) with punctuation (.).

 

All this back and forth on OCD posts with grammar and punctuation errors is driving my ADD brain crazy. I don't even know what the OP's post was about...

 

Very nice! Where is that desert spot?

 

That is Valley of the Gods out by Bluff.

 

Added some OEM rocker protectors. I don’t think they “protect” anything but they cover those ugly spot welds.

 

Not "today", but recently.

Got the Super Pacific on, 367lbs and I'd say with the truck completely unloaded, it looks damn near level.



Then the next day I loaded it up with nearly 300lbs of gear and a 350lb dual sport dirt bike. Wasn't lookin' so hot. I'm looking into some springs from Eibach or All Dogs Offroad. I'd include Dobinson, but I think they're fresh out at the moment.



I gotta say though, for being that loaded and ugly, it drove surprisingly well. Had to go 4H to get to our camp spot as the desert was wet so we had to find an alternative route into the dry spot. There were some deep trenches and steep approaches. All in all, I was impressed. Also impressed how cool the back of the Super Pacific stayed. Boris loved it.

 

Gotta love the steens! A Dobinsons 819-VR rear springs would do you solid if you can find them in stock

 

Gotta love em indeed. Been visiting since I was a tike. Never gets old. Tell me more about the springs! I’m so confused on what to do about suspension!

 

I went for the first time during 2020 covid. Couldn’t believe how cool that area was. I’d love to go back in the fall and see the small grove of aspens on top of the steens plateau! Must have been great with your camper

I put an order for a pair of C59-819VR Dobinsons rear coil springs. They’ll contribute 2” of lift + rake at any weight from 175-350lbs. Sounds like that’d be perfect for your unpacked weight of the Super Pacific and with plenty of lift left when weighing it down. They have a few coils higher in the range like 300-450lb and 500lb-750+.

I’m throwing on Timbren active offroad bumpstops as well for when I’m loading down a lot. They mush out the hard hits when loaded and they’re a bit taller for an earlier controlled contact rather than that brick of a hit on the stock bump stops.

 

Got my plates finally. Mounted the Cali raised ditch lights. Still need to wire them up! Stillen overland dump full exhaust installed as well.

 

Killer looking truck, my dude shell looks great on it. That’s the RSI?

 

thanks! This is just a generic topper. Does the job well though!

 

Well I posted this pic a few times but after today and pulling the ppf up past the gas flap and fixing up all the rock chips and a yearly ceramic coating I couldnt be any more happier today ...Yes my plate says Taco lol

 

If people are going to post, please respect my OCD and use correct capitalization.

 

What materials did you use? Looks great!

 

Thanks I am very pleased with it. A friend's shop did it for me so I'm honestly not to sure what they used but it looks like new again. Hopefully next year will look alot better then this year.