What Have You Done To Your 3rd Gen Today?

Changed out the factory tail lights for TRD Pros and added the vtails. I think it looks so much better, especially on a black truck

 

One of the best mods I’ve done. You have great factory quality tails with LED internals. Amber turn signals are much more safe as well.

 

This is the way

 

Washed, clay bar, and waxed.

 

(Because it is Friday)

It is totaled. Part it out.

 

Wheels and tires, loving the matte titanium on the lunar rock. Raceline Rogue on Wildpeak 275’s. Zero offset 17x8.5.

 

Spray a mix of dishsoap and water on it, if it doesn't bubble, you're good to go...no further worries.

 

Great wheel and color choice!

 

Love those wheels!

 

Part out?

 

Glad you like it man! It’s very nice. Also makes the truck look better.

 

I did quite a bit of research looking at tons of pics, Wanted a clean look, no fake beadlock, slight poke, and the methods are so played out imo. Almost went that route but saw these and went for it. I’d honestly have preferred a gunmetal but the lighter ti really works with the lunar rock…..better than bronze imo. Moved away from dx4 terrains with a -6 offset. Amazing how much more room I get up front with a 0 offset. Could have probably fit a 285 but compromised with a 275….love the look and less weighty tire. Super stoked on how it turned out

 

That looks good on that color truck!!

 

Oil and filter change, car wash, gas. Inside of the truck is still dirty.

 

Local trusted shop religiously, no leaks no issues. 0W20 full synthetic.

 

Been a minute since I've been on...I dunno why I never started a build thread. Anyhow, I've done a lot recently...

SSO front bumper & Smittybuilt winch:


Modified a molle panel to fit my HD bedrack to attach some Rotopax:


Added a 10lb propane tank mount to the tire carrier:

A buddy gave me his old platform he used in his back seat with his fridge slide. I carpeted it and added some recessed D rings to strap down the battery box I made topped off by a solar panel:




Then I decided I wanted a little drawer to keep straps and such in.

 

There is a lot of rubber between the edge of that tire lug/tread and the air inside the tire... Run it as is...

 

I've taken bigger chunks out of my arm and fixed it with duct tape.

It's fine.

 

Meso Customs V2 knob with the @oostroma kit to make it a toggle on off versus momentary. Highly recommend!

 

Yesterday I went ahead and installed ARP 7718s. These are intended for a Toyota Celica however they fit our trucks perfectly. No need to drill a hole in the backing plate of the drum brakes or trim the stud to make them fit in the rear.




I also removed the very crappy dealer installed vinyl wrap on the rockers. It’s a year old and already turning yellow.