For Stock Rigs Only

Washed and waxed the truck. I also did some hand polishing of some light scratches from the PO, but most of them are deep enough that I'm going to have to wet sand them, I think.

 

This is pretty cool.

 

Landed my first job under my LLC for new service wires, meter enclosure, ground rods, and water bonding. Panel was done ten years ago. Fuckers were too lazy to replace the feeder so they slammed a hole through the back of the panel right over one of the lugs and cut the cover down and joists so you have to slide the cover up into the joist bay to get the thing on. *chefs kiss*

 

When are we all meeting up to do that?

 

It would be like riding a wave with my fatass in the mix

 

Using a board...fine, I'm in
Body surfing...don't think so

 

If my skinny ass was next to you...would be a helluva bump.

 

My hair is getting that long too...

 

Trying to blend in with the locals?

 

Something like that

 

My ‘08 Tacoma just turned over 433,000 miles and still runs like a new truck and has the original drivetrain.

 

I was asked if this would work.

I didn’t want to get involved.

Any Opinions???

 

Morning
Nice day for a change..
Sore as F***.
Had a bowling Tournament last night.
Trying to get moving..
Snap
Crackle
Pop

 

Nope

 

Picked these up yesterday at Lowe’s , I think I’ll mow the lawn today, I need time to think about the installation process

 

It will look like when installed