1st Gen Lunchtable Thread - General Discussion

Yeah but don't rub it in

 

I saw that Moro said they're considering bringing a pickup back to the US.
Mazda quietly making killer trucks. I'd put a BT-50 in the driveway.
Also their interior design lately is so damned underrated.

 

Get a volvo

 

How good is that thing!?
Man I need more driveway.

 

I think its just a modified 240 lol

 

Of course but still good.
Put a bid in and buy a sawzall

https://bringatrailer.com/listing/1993-volvo-240-27/

 

Lol Yup

 

My first commissioned piece on the new table



Bent it up before turning in for the day, I'll weld it up tomorrow.



I'd say the beveling at this point is very much acceptable.

 

I'm slightly regretting not just doing the manual transmission swap when I found that kit on ebay for $1000. Ultimately I wasn't sure how it would boil down when putting an ecu from a Canadian car in.
I finally got eyes on the first flywheel bolt though

 

Our pup does not like thunder and we had a small hail storm roll in so she was hiding under the car with me

 

Your dog like

 

@Sperrunner
https://www.youtube.com/watch?v=EE50caXr8Gw

 

People sleep on volvo

 

My rental this week is a Volvo XC40, peppy little thing!

 

She's only looking up because thunder went off right when I took the photo. She hates thunder and made it extra difficult to crawl around under there

 

These damn flywheel nuts are the worst

I can barely get the socket in there and as soon as I apply pressure the flywheel just spins it out of position again

 

what CAM are you running with the new table?

I haven't spent any time trying to slow corners in the program on my F360 x fire control setup.... but I probably should lol

 

Fusion 360

I found out yesterday during test cuts that one or more options in my table's CAM software may not be enabled. The software is still relatively new and they're constantly updating it so that part showing the edges/bevel is all done on Fusion.

I don't do anything regarding corners though.

Also I learned that Feed Optimization rules do not apply when posting to my table's software so rather than having a rule kick in and cut a hole at 45ipm, I instead have to change the profile's cut speed itself.

 

gotta stick a prybar in there on the teeth to keep it from turning

my 09 was a real bitch to work on. if its anything like that it may be more straightforward to pull the motor and trans as a combo than to just pull the transmission out

 

acceptable??? looks great.