What Have You Done To Your 3rd Gen Today?

Welcome to TW!!!

 

Thank you!

I have a lot of stuff ready to go on but im waiting on my SSO bumper to be delivered and my Bilstein 6112's to be delivered. Got my 5160's, Icon AAL 1.5", Wheels, Tires and Smittybuilt 10k just sitting waiting on my front shocks which is killing me so im going through all the maintenance stuff so i have a fresh baseline as I plan to keep this truck for the next 5-10 years at least. 2022 TRD Off Road

 

Very cool, you'll have to show before and after pics...

 

Most of the "overland builds" here only see school and mall parking lots.

 

Looks fantastic! I got the leather Clazzios for the looks but am realizing in 96 degree heat the neoprene would be a better choice.

 

Anyone else running MRR's at close to factory height?
Just got these bad boys installed.

Recommendations for a resi hose wrap for protection?

 

How do I get the dome lights/crawl control plastics to stop rattling? I keep having to push it slightly but it starts up again after a few miles

 

Mine does, just replace the red quick fastener things. After I removed mine like four times it started to rattle but those red fasteners are all jacked up so I'm assuming they just need to be replaced

 

Mine was and the dealer just put a layer or two of felt (so they said) between the ceiling and the panel ... have not noticed it since.

 

Some goodies showed up today and still more on the way.
Hopefully by the end of the week I will have the bumpers installed.

 

Mine rattles. If you figure out what to put where, do tell. I have tried several times to get it to stop rattlin' using 1/8" foam tapes placed strategically, I haven't found the correct spot yet it still rattles.

I wonder what rattles, the clip in the roof, or the dome control in the clips? I think it is the dome control in the clips because right now I got that foam tape between roof and clip so that should be tight on my ride.

@RichochetRabbit if you said the stealer got yours to stop, any chance you can take a pic for the team and post it? I would like to know what they did. Did they put a foam block, like a 1"x1" up there?

@James2406 Where did you get the replacement clips? tia

 

I would have to pull the top panel. Whatever they did is entirely hidden, so they could just have easily fully replaced that panel and lied to me.

 

Looks like the Hi-Lite High Clearance bumper correct? Sweet.

https://backwoodsadventuremods.com/products/2016-tacoma-hi-lite-high-clearance-rear-bumper

 

Yep, Backwoods Hi-Lite front and back. They have been on my wish list for about 4 years now. TruckBrigade.com had them at a really good price, I ordered the support brackets and connector skid plate directly from Backwoods.
I really like the swingout rear bumper but $4000 is a bit out of my price range since I got both of these bumpers for that price. And I use my truck bed for work and hauling material so having a swing gate would just get in the way.

 

OEM black lug nuts on my SX wheels.

 

any chance you could tell me where you got these. I'm looking for a black set for my offroad rims thanks.

 

My wife made me an Adventure Taco decal to put on my high clearance bumper.



Still a work in progress.

 

My OR is starting to identify as a sport… I put a front spoiler/air dam on it for towing purposes a couple of years ago and have just scored a set of studded Hankook winter tires/wheels that have less than 2,000 miles on them for $300!

 

I got them from Amazon actually.

https://a.co/d/d2ffqz1

 

thank you very much