HID Install Help

Below are pics of what I have. The problem is the hid's are low beam only but aren't working when I turn the lights on low. They will turn on when I put them on high beam but it's supposed to be regular lights on high, not the hid's. They were prewired with the Hid's already installed so I didn't mess anything up that end.

 

I had to uninstal them and put stocks back on so I'm not sure. I'm going to try again Wednesday and will try to take more pics if I have the same problem. Hopefully I won't - going to be pissed if I have to do this more than twice!

 

i assume those are projectors? i hear they are a biatch to wire up

 

I had the same problem, but its a simple fix if yours are like mine.

In this picture you have the new wiring harness, with the blue and red wire and what looks to be black? Now for me I had two red wires but it would be the blue and red wires for you. What you might have to do is unplug the connection in this picture and switch the blue prong with the red prong. For me all i had to do was swap the two prongs and it was fine. Just take a look at it and see if you can get them out and then swap them. If you cant do that then i dont know. but it worked for me

 

LOL, well $hit, I didn't know that. So basically it looks like the wires are probably mixed up and I'm only going to have HID's on low and no hi beam? If the Hids are bright enough hopefully I won't need high beam. The HID's were pre-installed I didn't have the option to choose. If they are the same amount of light does it matter?

Thanks for the help guys, hope to have time to fix them tomorrow.

 

Well, after 4 hours of trying to figure out how to wire these things I gave up. I'm just going to sell these. The wiring for the LED angel eyes ect. is a pain in the a$$.