Ripped CV Boot? help

I just got back from the dealer and they said the cause of my ripped CV boot is from the steep angle of the axle. My truck has a 3" spacer lift. Does anyone know how to prevent this from happening again or maybe someone makes a bigger boot?
help please

 

You can get high angle CV's I would highly suggest a diff drop for sure A combination of both will definately make your cv's last longer

 

definitely i recommend the diff drop.

 

+1 for diff drop

 

+2 for diff drop costs few buck ,takes 15 mins and saves you $$$$ down rd

 

I got the diff drop with the lift but I'll look into the cvs

 

the stock boots should be fine, aftermarket ones never seem to fit right. but defently do the drop..

 

I just finished ordering my bigger boots from allpro offroad. Thanks everyone

 

and a diff drop, right?

 

X2, also your going to need a pair of Snap Ring Pliers. and some tape...

 

yes I already have the diff drop. I installed it with my lift.

 

ahh just saw that up there... all apologies...

 

Did you get new grease packs with the boots?

 

ha no prob man. Thanks for lookin out for my yota though

 

Grease packs? I didn't see those listed on the allpro website

 

99.9% of the time a cv boot kit comes with grease packs

 

I would call and check...

 

K will do

 

and also make sure you mark where the Tulips come off with a marker or something so you put them back the same way they came apart. and also wrap them with electrical tape other wise they will fall off and you will lose your needle bearings.

Good luck.