how do i take this off? HELP FAST PLEASE

Do I just hammer this off? Is there bolts in the back? Got the caliper off. Or do I take off the ball joints first? Im Replacing my bent steering knuckle. I already got the big nut off in the middle

 

you can run 2 bolts in the holes and those will force the rotor off the hub... not sure the size.

 

Those 2 bolt holes take a bolt that you screw in and it pushes the roter off

 

see the two little threaded holes?
you should be able to put a bolt in them and screw it down to push the disc off
sorry, don't remember the size. 10mm I think

or a few whacks with a rubber mallet

 

So I keep tightning the bolts until it pushes it out?

 

yes

 

I'm assuming your trying to get the rotor off, but if you can find a screw to fit into any of those two holes on the same ring as the lug nuts then just thread them in. It should push the rotor off.

*Way too late on that one!

 

Have you tried hitting them with a mallet, that usually does it. I only had to do the bolt holes when they were old and rusty.

 

or rotor cracks
BTW those holes need M8 bolt

 

just hit the rotor with a hammer,do not hit it on the face of it where the pads make contact, hit it on hub part and make sure not to hit the studs.

 

I was talkign about those bolts. If you thread them and keep turning to push rotor out either rotor gets free or it cracks (ask me how I know this )

 

Thanks. Got that off. What about this? There is 4 bolts in the back. Got those loose but it still wont come off.

 

Do they need to come out to replace the spindle?

 

Rubber mallet or a dead blow hammer will be your friend for the rotor and the hub assembly you just removed the bolts from.

 

It did, and now I have stand for metal work (welding )
I have ogre hands