Which of these rims look better?

That's gonna look awesome on your truck! Post pics after you get them installed.

 

i like the procomps...but the revolvers are sweet also,i have procomp 7105's(machined lip) on my truck,but after a while they look a bit plain...the revolvers are a much bolder look.

 

kmcwheels.com/wheels/?wheelid=XD8012&siteid=3&groupid=46#

Is post pics, but this is from my phone. The cranks look like a revolver update. Check em out. I like these.

 

Will do

 

revolvers

 

I like your old moto metals the best

 

check out the Cranks on this build


http://www.tacomaworld.com/forum/2nd-gen-builds/155157-t4c0ch40s-build-4.html




I've liked the Monsters the best and the revolvers at a close second. Now the Monsters are getting too common for me, but these XD Cranks are like a refreshed version of the Revolvers.

 

Yep

 

Thoes look awesome with the nitto grapplers, got to get me some.

 

Both good looking rims but I would go with the one that is easier to clean

 

Pro comps look pretty sweet

 

Yeah, some guy down the street from me has these bad boys on his Dodge. They look really good in person...and not everyone has them yet. those tires are the trail grapplers

 

revolvers. i was going pro-comp because they was a little cheaper but like someone said earlier they seem to be having issues with products.

 

jdenny15 commented on the durability of the procomps vs the xd's...they're both manufactored the exact same(low pressure casting) and probably made at the same factory in china...so durability between the two should be about the same.the fact that someone bent 2 procomps in a week is probably just " buzzard luck"...the black wheels from most companies these days are basically the same...i have procomp 7105 on my truck...for that "offroad" look...but i wouldn't trust any of these wheels in serious offroad situations...if i was into that,then my choice would be a "forged,hubcentric" wheel.

 

I like the pro comps because of the deeper lip

 

Those cranks are sharp!

 

The Cranks are cool but wish the ATX Chambers were still available

 

XD, imo. I was looking at the fuel octanes for my mine, very similar wheels. Lets see it when its done.

 

Revolvers

 

Just got back from 4Wheelparts and I'm incredible stoked!!! I'll post the pics of the new set-up tomorrow