Need your Help

OK Guys for a long time I've been stressed with the dilemma of where to mount my Brake controller. I like I nice clean looking truck and I didn't want to drill any wholes into the dash of the truck that might be noticeable if I ever had to remove it when I was ready to sell it. I also didn't want it to be in the way of anything but I Finally figured it out. There is a pocket on the left side of the Dash that also acts as the cover for the Fuse Panel. I want to take that pocket and cut the back of it out so that the Brake Controller can slide in far enough that I can open and close the pocket still. This will allow me to have the pocket closed when I'm not using it and opened when I am using it. I can't wait to have the controller permanently mounted. What I need your help for is I don't want to use my original pocket I want to order a new one from the dealer so that they can easily be swapped out if I ever needed to. I know this part is color coded because It matches my gray dash and the wouldn't put a gray pocket on a Tan dash. My Local dealer is not able to find this part in there system so I was hoping you guys will be able to help guide me. I promise to take pictures of the install as soon as I have the replacement part. Thanks for you help in advance.

 

Junk yard. Pick-n-pull place.

 

Please excuse me...but what is a brake controller please?

 

LOL I've never heard it explained that way. Now I think I want to go on U tube and try to find this scenario because that would be hilarious to see.

Thanks for the mental image.

 

Thank you Colton! I understand now.

 

So Apparently Junkyards aren't up to date enough in Florida to have 2005 and up Tacomas on there u pull it lots and they wont part out those pieces of the dash because it will make selling the whole dash Assembly harder for them.