Florida B.S. Thread

Mine went smooth I will give you a hand

 

i was about to say that it should be easier since the metal's already bent out of the way.......oops

 

Yes underneath

 

lol, putting the stock ones back on the old truck was a breeze, I also had the help of my roommate. When I first lifted my old truck I did it solo, I lost my temper on the UCA's

 

i hear ya...the instructions that came with my first lift estimated 45 minutes to install. 3 hours later, i realized there were 2 people in all the pictures.

 

yeah i did mine in 3 hours

 

i can swap out a set of coilovers in a half hour now, but that first one sucked. it was also in a cold garage with 2 feet of snow on the ground.

 

They look tough what did you pay out the door?

 

mine took two days because I had to replace a spindle and had no idea what I was doing with it. Plus I had the OME coils with the lift enhancer kit so the top bolts were crazy long, the getting the one nut closest to the engine took me about 30 minutes alone. Even recently when I took them off.

 

yeah, that bolt does suck.

one of these will make your life much easier

 

so i had toyota replace my lower control arm and now that side wont let them align it properly im riding around with 4.0 caster 1.90 L and .9 R camber and the toe is fine FML

 

holy shit......did the new bushing sieze and they can't physically move anything, or is it all moving and just not lining up right?

 

just aint adjusting correctly they arent seized or nothing but the driver side adjusts to the right specs fine passenger side nothing

 

well damn. do you know how the got the old arm off? if they pressed the old bolt sleeve out they could have tweaked your lower mounts. those things bend far easier than they should.....

 

im not sure how they got them out.... i would exspect toyota to do it correctly i will be at toyota tomorrow though

 

im gunna argue with them then a duel

 

hahaha