wet C/V boot

After changing my UCA I have a C/V boot that is wet like gear oil.

 

Which boot? Any tears in either boot? Can you trace any oil up your half shaft to your diff? Pics?

 

Pass side No tears its all post like its bleeding threw Ill go take a pic

 

I found my problem,looks like the boot wore a grove against it self

 

make sure it doesnt look like this

 

It's happened a few times on here. And it's happened to my dad's Porsche pita to fix. If that's what it is do some preemptive maintenance and replace both. You may also want to look into the Boot Slide Mod to keep that from happening again. http://www.tacomaworld.com/forum/1st-gen-tacomas/146070-boot-slide-mod-no-more-blowing-cv-boots.html

 

Changed both sides yesterday,I killed both side dust covers getting them out,I tryed being nice then I was on.Not to bad of a job once you do one side and see how it all works.

 

Lol I've been there. One side you're cussing the entire time then the next you're surprised at how easy it is.

 

From to much lift. Check out the Boot slide mod.

 

Thanks allready cked it out and did it,this forum has some great HOW DOES greywire mode/deck lead mod/slide boot mod are all on my truck.I put the OME shocks and coils back on,cant take the beating on the frwy,

 

lol seriously? lol hows about you send those coilovers and UCAs over here