What Have You Done To Your 2nd Gen Tacoma Today?

I just sprayed the inside of the frame that is boxed in towards the front of the truck with Internal Frame Coating. Hoping to prevent any future rust. I'm going to paint the rest of the frame with some Rust Bullet. I used the Rust Bullet on my old Dakota and it kept the frame rust free.

 

did you spray the Rust Bullet with a primer or just went at it? going to be bagging a homies impala soon, don't want to hassle with primer, then paint, etc.

 

I loaded mine up with a tree, that was needing to be cutup in my yard. I was surprised that with a full load of tree that the ass end did not even squat. I ordered a 3" lift kit for my truck today.

 

No primer..I just cleaned the fame and made sure there was no dirt on it. I brushed it on. 1 coat today and I'll apply another coat tomorrow.

 

NICE, when possible post up when your done. I wanna see how it turns out

 

Ok..I'll take some pics tomorrow after I put on the second coat.

 

I want that! How/what/where/when?

 

ooops n'm read post wrong

 

SWeeeeett

 

Scored a set of mint condition 08 FJ 16" wheels for 50 bucks (for all 5)! those went on last week. Ordered an Avid lightbar and some 130w black KC Daylighters (driving beams) today. Threw in a proper Toyota switch from TRDSparks as well.

Headed to the hardware store to build the little DIY PVC TPMS sensor container since the ones from my steelies didnt work.

 

Changed plugs today. These were in longer than they were supposed to be at 58K. Plug gap had expanded to .050 -.052 due to wear. NGK's electrodes were well rounded compared to the Denso's.

I installed

$6 Denso PKH20TT Platinum TT Spark Plug, (Pack of 1)

Denso PKH20TT Platinum TT Spark Plugs. They were a buck less than the coppers which I would have to order. WTF is up with that?







Possible seal leak on the one Factory Denso.

 

Ordered a valley hitch and a set of piaa 510 driving lights.

 

finally got to use my 4x4.... rained all day in oklahoma and went and found some muddd. even the wife had fun! been waiting forevers. wish we had trails here in Oklahomo!

 

Nope. Completely stock including the pre-TSB springs. I'm still trying to decide what to do with the suspension.

Tires are 265 75 16. Performed awesome in the snow today (6 inches with a lot of shoulder & between lane slop).

 

Blacked out the badges, currently drying in the basement. The paint looks a little gritty, like sand paper, I hope they look ok. Either way they are going back on the truck tomorrow afternoon.

 

colormatched

 

changed my rear dif fluid, transfer case fluid, was to lazy to mess with front dif. will do that sometime this week. and i soldered the restrictor in my display back so now it works again! fairly productive day.

 

Tomorrow I am going to rebadge my truck and solder the overhead display, hopefully all works out well for me.

 

I bought floor mats and seat covers So epic, so daring, I know....

 

just follow the instructions on the site and you'll be fine. be careful not to lose one of those metal clips when you pop it out, and be super careful not to snap the plastic ones off of the display screen. i broke one but it's fine. . . it was obvious which restrictor was out too. it was popped up on one side. did a shitty soldering job, threw it back in there and now it works fine.