how do I add more lift to my 3" lift???

What are some ways to add more height to my current 3 inch PROCOMP lift? just one or 2 more inches, I don't want 6" because I won't fit in my garage.

a guy at 4wheelparts mentioned spacers, how does that work if I already have the suspension lift? good idea or no?

 

good idea? no... possible? yes.

another question.. do you have stock UCAs?

one last question.. you could get a spindle to lift if some..

 

1" body lift would be fine.

 

One word... SPINDLES

 

yea they're stock, and why is it not a good idea to do that???

I've only seen 3" body lifts for my 10' taco, who makes a 1" one??

i looked up spindle lifts, i dont like how its really uneven like so...

 

http://www.tacomaworld.com/forum/sus...e-read-12.html

 

excellent info man!^^ so after reading that I think I should go with the spacer lift on the front to go along with my 3" procomp since my truck will never see dirt off roading, I'd much rather be taking turns over 100mph on the bike rather than washing my truck lol. Now with that said for the rear what should I do? b/c the procomp lift already comes with the AAL right, so can you add another or I must get a bigger block???

 

ok so i think im just going to go with the 1.5" spacer from fat bobs garage, because that should even out the truck since the front still sits a bit lower than the rear....any objections? or will this cause something bad in the future that i dont know about????

(again im NOT off roading....ever! so im not concerned with that type of performance)