stud and lug nut both spinning.... HELP

ok so I was trying to rotate the tires when on one of my wheels I came across to like this on the same wheel. well for the last idk 3-4 hours i've been drilling the piss out of them trying to break the nut off so far ive been through about 5 bits and only have one off and the second one just refuses to come off i don't know if i'm just doing something wrong or is there another way to get it off i'm tired and got to finish it tonight and I NEED HELP!!!

 

take a mototool (dremel) and cut a slit along the lug nut parallel to the lug. it should relieve the pressure on the nut. An air chisel would be easier if you have air tools

 

well the problem is everyone else is asleep and i'm using my dads tools i thought about using a dremel to cut like one side off and then just pryinging the rest of it off you think that will work?

 

thats kinda what i meant. even if you only cut one side it will relieve pressure and you can spray with pb blaster or wd40 and let it soak a while. cut two slits 180 from each other and pop the halves off with a screw driver...

 

thanks for the advice man i finally got it off after almost 5 hours. ha ha.
man eventually i just beat the piss out of it with a hammer and it broke off FINALLY!!

i was about to go

 

I was going to say, as a last resort a BFH works or a big breaker bar to snap off the studs.

 

well i kept using a tire iron at first and then it got to the point i bent the damb nut so much there was nothing to hold on to anymore.. but thanks again for the help guys i was up till 330 getting that tire off and had to be up to go to class today at 9.