F***! Help!

Finished installing my lift today and the VSC, ABS and Brake light came on and stayed on. How common is this? Will the recalibration help?

 

Not That I know of.

 

This...

Can easily happen if your not careful when You disassemble the front control arms linkage. If you let them hang and didn't support them this is most likely your problem.

 

/\/\/\ He's smarter than he looks, probably this.

 

I supported my spindles when I installed my coilovers and uca. FML!

 

Would it be safe to drive to the dealership 20 miles away?

 

If your not leaking any fluid from your brake lines or calipers you might be ok to drive it to the dealer. Just keep in mind you don't have ABS so if it's wet or rainy be easy on the brakes.

 

Checked if there are any fault codes using Torque, and there are none reported.

 

Ok.

 

Can you check the wires with an multimeter? If so what reading are you supposed to get?

 

set it to ohms and if you get .1-.5 your good if it's higher than than you have a broken wire

 

Well....I am a DumbA**.....I found the broken wire. It is right above the rear differential. How much would it to replace that plug at the dealership?

 

Shit happens man, fix her up and post up some pics of the truck.

 

depends on how and where it's broken you could get some heat shrink and solder it back together. other than that its going to depend on how much of the waring harness you're going to have to replace.

 

Well it broke at the plug and there is a lot of slack.

 

Yea dealership already said $100 to bring it in to be looked at.

 

Can you post a picture of the break? might be easier to help you fix it if we know what you're working with.

 

Found the wire. It broke right at the plug above the rear diff.

 

It is already dark....I try and get a picture of it tomorrow.