What Have You Done To Your 2nd Gen Tacoma Today?

Well, my skids werent done at the forming shop til yesterday(was supposed to be done last week) and Max goes to school right down the street and was able to come by short notice, so it just worked out this way. I was just too anxious to wait.
Cant hurt to test fit on anther rig still though!

 

installed my trd exhaust system in under 30mins haha

 

riiiiiiggggggghhhhhhtttt!!!!!!! LOL

 

No problem call me if you need mine.

 

D A M N ! Way to go.

 

Iv been waiting a looong time to see those!

 

Yep 1.25" with stocks. No improvement in cornering/handling and despite what you might hear, a negligible if any increase in wear on your bearings.

 

yeah they're definitely over due!
Just uploading some better pics now, will post from my computer later tonight.

 

hurry up!

 

What brand is that topper?

 

Ordering my front plate bumper

 

Pics are in the 'Other relentless fab products' thread.

 

Not something I did to my truck, but it is a concept for something for my truck. What do you think?

Brute Force Concept Bumper:

 

Looks very much like a RelentlessFab

 

Not sure I see the similarities to a RelentlessFab. Those have only a vertical plate and the angled plate that goes down under the truck. The one above uses three plates. I would say it looks somewhat like a DeMello more than a Relentless.

 

Huh

 

On a Relentless bumper, The center section is made of two plates. One that has several circle holes in it and one that has the cut outs for the winch with a circle on both sides.



On both the DeMello and the Brute Force, there are three plates in the center portion. On the Brute Force, The top most plate has access holes for the winch, the center plate has the recovery points and the cut out for the winch cable, and the lower plate has triangular holes in it.



Make a bit more sense now?

 

I see what you mean

 

Looks great, now my brain can slow down and quit trying to figure out what they look like.

...and bring your checkbook.