Long Travel BS Thread

Yes i have a set of spindles on the side ready to go

 

Oh wow I might feel bad taking pizza then

 

Whatever you want. Beer. Beer and pizza. No matter. I got ya

 

http://www.youtube.com/watch?v=gd585Ld7L00&sns=fb

 

Anyone have a 2" jd tubing die I can borrow? Only need it about a week.

 

I've been looking around for a second set as well to do the same.

Anyone have any?

 

Ill be getting race spindles in a few weeks. But im not sure I want to get rid of my stocks for spares. Ill let you know

 

http://inlandempire.craigslist.org/pts/2834801558.html

 

Unless you actually want spares you dont need them just to gusset. You just pull a wheel off and disconnect the upper arm and that is plenty to weld. IIRC Username welded his on without removing anything

 

I do kinda want spares to play with double sheering the tie rod end to run a heim

 

Oh! nice find. I could have some fun with that

 

Is there any recommended sliders for LT trucks? I am not going to be rock sliding I just need a solid Hi-Lift point on the side of the truck. I figure just getting a minimal bar welded should be enough. Any ideas?

 

love my 4xinnovations sliders


Havent really had use for them in the dirt.

Im scared of hi-lift jacks after a couple 'incidents'

I just use my floor jack now.

 

X2 my floor jack fits under there just fine. Front and Rear

 

been planning on doing this on mine. single tube tucked nice and tight. a place to use a hi-lift if necessary and a little body protection..ill build ya a set when i do mine

 

Hopefully I'm in town when you do.

If rather have it and not need it. I have a HF compact jack right now but I'm planning on getting a Hi-Lift as a backup.

 

i didnt remove anything either haha

my sliders are from avid, and i have beat the hell out of them with no problems.