FS: 2nd Gen Smittybilt Light Bar

FS: 2nd Gen Smittybilt Light Bar. Will fit 2 or 4 lights has small mark on the bar but isnt noticeable when on truck. Asking $125.00 Shipped OBO. Has all bolts, nuts, and washers and alll mounts.Will think about any trades you may have dont be afraid to ask the worst I could say is no.

 

Bump

 

any pics of it on the truck? jw

 

not at the moment im at work right now, I get off in like an hour and a half ill put it on and take a pic.

 

Bump

 

Here's a pic of an Nfab on the truck, same as the Smittybilt one the OP is selling. Only difference is mine was hit with a coat of bedliner.

 

Thank you man been trying to find a picture of it on my truck but dont seem to have any.

 

No problem. I've got a few more in my pictures so anyone looking for pics on the truck, take a look.

 

Bump Will Lower to $100.00 OBO shipped

 

$100 is a good deal.

 

Thanks man Wish someone would take it soon..

 

Does this require any drilling or modification to the truck at all?

 

No drilling or modification needed at all it is all bolt on, it goes threw the opening in the bumper of the truck the triangular pieces bolt to your frame and then the bar itself bolts to the triangular mounts. takes about 30 minutes to get it bolted on.

 

All screw holes that you need are already located on your truck.

 

Bump

 

Does it give at all or bouncy with lights on it.

 

I have this same bar. You have four bolts on each side going against eachother where it bolts to the frame. You could probably drag your truck with this bar (don't try it, please)

 

Unless there's something inside the lights that allow the beam to bounce (cheap light housing), they won't bounce at all. It's a very solid mounting point for lights.

 

Pm'd

 

this bar is very stable there is no bounce in the lights and I agree you could probably pull ur truck with it but I dont recommend it