Maxtrac Spindle Lift for 2nd Gen Prerunners

does anyone know if it will throw my camber off any if i install them with 3" spacers (already on)

 

markmatters,

how is your ride with the new setup?

 

I got an alignment rides good but wheel tilted to right slightly, and also very slight drive to left. Might go back and have them check it...

 

Mine was like that untilled I got it aligned now its perfect. You should really take it in.

 

Ya. Ima take mine in after the no pavement run since I have a 6 month warranty.

 

are these a true 4"? doesnt look that high compare to camburgs.

 

Camburg is not a true 4" lift either. If you dont offroad hard, dont bother spending so much. I love camburg. I have thier UCAs but if you dont plan on wheeling hard, go with maxtrac.

 

meeeean!!! thinking of buying these for my brother as a bday gift. He's also running rear dakars, you folks think it'll be even? (no bro lean style braah)

 

thanks!, i was set on buying him the total chaos spindles, since it's only 3.5" and he wants it even with his dakars. Might just pull the trigger on these now, since its way cheaper.

 

Well if he wheels hard then I'd go camburg. If not, maxtrac can handle a lot too. That's very generous of you! Haha

 

What are you running on the front?

 

Maxtrac 4" spindles, 5100's at 2.5".

 

were you able to get the camber right without ucas?

 

looks good davtopgun

 

Thankyou sir. I absolutely Love it!

 

that is sick bro

 

Sweet!

 

U got 35s?

 

Currently stock UCA's. They were at the top of my list on next to replace, but i got lucky and got a good alignment out of it. So they have been bumped to the bottom of the list. Rides a little stiff, but still far better then my previous spacer lift did.

Thank you sir!

Thanks!

Yes, i do! I previously had the billies at 1.75" with 33's and just thought the tires looked to small. I then decided to put the billies on the top notch and throw some 35's on there. Damn, what a difference!