Front axle seal part #

Ok so I'm new to tw and I was wondering if any of you have or know the part number for the front axle seals. My father was helping me swap out a cv axle and it was a real pain in the rear so we just went to town on it and damaged the inner seal

 

Thanks a lot! I searched everywhere and couldn't get a straight answer

 

Good luck with them, if you dont have a slide hammer it will be harder to get out the cv axels. Saves you alot of money though, so worth it.

 

did you ever replace the axle seal? im having troubles installing the new one on the driverside

 

I had to change both of mine after a horrible stuck in a deep mud hole. I believe I got instructions from TTORA. Basically once you get the CV's out, pop the old seals out with a flat head screw driver, or claw hammer (very carefully), and tap the new one in using a 2x4 block and rubber hammer to make sure you dont put them in too far or unevenly. I just stuck it in part way by hand, placed the block on the diff oil seal and tapped in a ciruclar motion until they were in. Havent had any leaks since.

 

thanks.. does the part number for the drive side end in 12 or 13? i may have the wrong seal. it seems like it doesnt want to fit

 

ok I have the correct part but it just doesnt want to go in there and i dont want to ruin it. I have a bearing race and seal driver set. sizes vary from 1.565"-3.180" Im just in need of help lol I know I can do it but just need it to be explained a little better