Oregon and Washington BS thread

I just ordered a Scosche kit for the dash. Gonna try and mount my CB in the lower pocket

 

Yes and yes...still working out what I'm gonna do for the final install. After seeing your antenna mount Mike, I think I'll just pay the $20 for Relentless to send me one.

 

¿Por qué

 

Hey keep in mind that you'll have to trim the feet that the clips mount on. I busted my first one by trying to make them thinner, but you have to make them shorter. A nice flat rat tail file does the trick.

 

Thanks for the heads up. Im gonna take this really slow to make it fit flush

 

Nice truck! Pretty much everything East of the Cascades. Lot of high desert over there. Plenty of dirt side roads that shoot of main roads in the rural areas. Username, is up in Pendleton and runs a 2nd gen with all the LT goodies. I would message him. He would have specifics.

Edit: Christmas Valley and Millican OHV area aren't a bad start.

 

Looking for winches on CL, found this guy:

http://portland.craigslist.org/mlt/cto/2971150900.html

Anyone you guys know?

 

Are you buying a plate bumper?

 

Probably go with a undercover winch mount with some added shackle mounts like this guy did (I would do it a little differently though)

Call me stupid, but I like the way the stock bumper looks. I've never really been a fan of plate bumpers.

 

That's Jason! From Oregon TTORA chapter, he did the last October TSF run with us.


Derek, if you haven't bought CB yet might want to consider this one. Within your budget but not sure with shipping:

http://www.tacomaworld.com/forum/buy-sell-trade/217901-cb-radio-spacers.html

 

You're not alone

 

See below, one slice for you

Are you sure? I thought he had an 01? But that did cross my mind as well

Here is a slice for you too... Now give me some jelly

 

I especially dislike the All-Pro bumpers....

 

AAHAHAHA! Dont forget your creamy peanut butter! Crunchy FTW!!

Yeah that's him..I recall posting in his FS ad also

http://www.tacomaworld.com/forum/1st-gen-tacoma-marketplace/198874-sasd-1998-toyota-tacoma-trd-limited.html

 

Me too... I'll sell you it

 

Thanks, but I'll have to pass, I'm saving up for a bullbar and tubesteps

 

So much protection

 

Hahahaha

No flaming here. I haven't found a plate bumper that I like. My only concern on a setup like that is what will insurance say in you get in a front end accident? Since you have to cut a support to install that. I do like his set up though.

 

What are you talking about. That's all that's needed in the mall parking lot

 

I was kidding.