Switches

How do you pop out the small switch blanks next to the cigar lighter? And how do you get back there to work? Thanks

 

I use a little angled pic to pull out the switch blanks. As far as how to get in there, pulling out your radio and a/c controls will give you the most room. You could also remove your center console if you need access underneath the cigar lighter.

 

Heres a vid on how to do it, it took 4 min.

http://www.youtube.com/watch?v=E_lhVFJGIKs

 

Or you can take apart your dash to get behind there...


http://www.tacomaworld.com/forum/au...sb-charger-connection-port-factory-blank.html

 

Nice find

 

Yeah I have it saved....I have a LOT saved so I don't forget them, sometimes I even convert them to PDF so I will never lose them

 

pretty sure that the 12's differ a little bit from previous years.:not sure:

OP, if you could, can you please verify after you tear in to it? thanks!

 

If you plan to drill a hole for a new switch or dont care about the blank, I just took a wood screw and put it in half way,,,,,,then pull....comes right out. If you place the screw strategically then its just a pilot hole for the new switch.

 

Drywall screw and pull out using a pair of pliers.. ^^ We think alike^^.