Has anyone installed a TruSpeed recalibrator on a VSC equipped Tacoma ?

As the title states , has anyone installed a TruSpeed Wheel Speed Sensor recalibrator on a 2009 and newer Tacoma ?

http://www.superlift.com/accessories/truspeed.asp

 

How much $$

 

You could use this one http://www.hypertech.com/products-speedometer-calibrator.aspx
Plugs in to the OBD port, no wire splicing required.

 

Have you seen that one work? Cause the heal tech site points at an inline chip to use for the 2nd gens.

 

Didn't read that, good catch

 

I've used an inline on my motorcycle but the wiring was easy because it was made for my model of bike. Not sure how tough wiring an inline would be but it works great on my bike....

 

Anybody install one of these units on a VSC equipped Tacoma ?

 

Do not overpay for that damn super lift unit.
I use the Yellow Box.
http://yellr.com/

If I was you, I'd try splicing in behind the cluster on the signal wire.

 

I don't care about getting the speedo correct , I wonder if correcting the wheel speed sensor info correct will eliminate VSC engagements

 

really interested in this as well. i had one on my 04 taco and it was amazing... imo that hypertech chip is a piece of shit. i have tinkered with mine for months and its still off.

 

I'm using the hypertech speedometer on my 10 dc sport w/35's and have had no problems, programing is easy and then it's a plug and play installation

 

Did you have any VSC issues prior to using it ?

 

Bump

 

I have not had any VSC issues.I installed speedometer,lift and tires at the same time,so i'm not sure how truck would have been without it.

 

Thanks