Dremel Kits For Satoshi??

I looked everywhere for the Dremel Kits here locally and they have them but for like 50 bucks (CHEAPEST) and i know a couple of yall discussed before about finding some for about 10$ that werent too good but got the job done? any of yall know what brand these are and what I'm talking about?

 

www.harborfrieght.com

 

Thanks man!

 

no problem!

 

I got mine at harborfrieght for 8.99 does the job!

 

Is harborfrieght like a north us brand or what? Never seen it down here

 

I just used a Dremel tool today to cut the crossbars from my grill for the Satoshi mod. I wouldn't recommend using a Dremel tool for this project unless you have the patience of a saint.
It would have been much easier to use a sawsall or hacksaw, neither of which I had readily available today.
The only way to accomplish this task with a Dremel, is to use the drill bit and either drill individual holes, which takes forever... or start a hole and use the drill bit as a router, which does a better job of melting the plastic rather than cutting it. It worked, but it was frustrating and took forever.

 

so is there a way to install a satoshi grill while keeping the option of putting the stock grill back on

 

ill take that as a no

 

satoshi is a one way option. no going back. I do recommend using a dremel for doing the satoshi. For just cutting out the stock grill center, yeah it was a little tedious, but the dremel is necessary for the fine cuts to keep you from sanding 10x longer.

 

i started with the dremel, then realized it was a pain. so i used a hacksaw blade which made quick work of getting the grill out. then once it was out used the dremel to cut/grind the remaining plastic flush were you will fill in with fiberglass. worked good for me.