What have you done to your Tacoma today? 1st Gen Edition

can't see them. Take a better pic so we can behold their glory.

 

dont really have a great pic but i hope this one is better, just out for some sunday evening flexin

 

Extended my rear diff breather up to the plastic shroud around the gas filler and installed an extended rear brake line I've had sitting around since 2005 Also installed an aluminum BPV bracket, made it myself

 

Got rid of the brake light ans ABS light today. tweaked around with the e brake line. Then cleaned the ABS module connector and topped off the brake fluid.

 

Went to Meatman's house and helped him mount and wire up his new switches.

 

Cleaned the throttle body and maf sensor. Washed the outside, cleaned the interior with armor all and vacuumed. Its a happy taco now

 

All I could do today was sit and stare at my little Taco.
Can't work on it until me and my best friend are done building his garage, because that's where we'll be doing the tear-down.
Can't wait to work on this sucker!

 

does anyone know if there is a seal kit for the rack and pinion? I have found my leak.

 

I finally have more clearance for the curbs at the mall!

put on these bad boys yesterday:

 

found the seal kit just not sure which one..

http://www.rockauto.com/catalog/x,carcode,1317633,parttype,7396

I'm almost thinking the $25 one.

 

Either way..looks like your gonna have to take the whole rack out shitty..

while your at it get new bushings too.

 

I had to get new bushings when I got my ailment done back in DEC. Glad I found the leak.

 

Where'd you (or he) get that switch plate?

 

That is a pretty sweet switch bank.

 

On my '98 Tacoma I changed all the lug nuts. Now they match. Yeah I had to have 'em match. I got chrome acorn nuts. And I added some trim rings. It looks really good. At least I love it.

 

We made it out a black plastic

 

Thanks man I think it turned out great myself

 

how did you mount the switch plate in that area under the deck so that it wouldn't push in/ pop out?

 

Check engine light was on, when to Autozone, they hooked up meter and checked my code. Front 02 Sensor, they wanted $189.00 for new one.. Dont' think so, came back to this forum, found http://www.rockauto.com/ for $80 ... duh.. same Denso part!... replaced Sensor, Nuts came right off after 11 years...
Went back to Autozone, they reset my code... No more Check Engine..

Sweet!

 

I took the pocket faceplate off and if you've ever notice that the radio dash trim has a notch around the radio opening. Well I made the panel fit that notch and the pocket holds it in tight. I'll post up more pic tomorrow as I do mine.