Maxtrac Spindle Lift for 2nd Gen Prerunners

Maxtrac spindles, 1.6" eibachs, bilstein 5100 set at 1.75", 1.5" aal and 4" block!!! I'm at 29 1/2" front and 29" in rear from center of hub to fender...will add better pic once the sun comes up

 

Btw...it rides and handles
Like shit and will be coming down some today

 

I was just thinking that as I was reading it. I have the 1.6 eibachs with 5100s at 0 and it rides pretty damn good.

 

Put the bilsteins at 0 and remove the block....mine rides so good up front

 

This... Do this.

 

So I went with .85" setting with eibachs and replaced 4" block with 2"...also removed sway bar

 

So finally did the install today... Me and a buddy.. Took our time and we were so tired from lack of sleep.. Took us 4-5 hours... 5100 all around,stock coils, wheelers 2in add a leaf and spindles... 5100 make the truck ride so much smoother....

 

Forgot to mention... Those are 265/70-17 General grabber at2.. Measured 25in for the front and 25in and about 1/5 of an inch in the rear.. I'm Sure the rear will settle a little bit.

 

great job! what do you have the 5100 set at in the front?

 

I set them at 0. I wanted it to be leveled. Any higher and I would be nose high.. Nice is alot smoother compared to stock.

 

Looks awesome dude!

 

Just ordered maxtrac spindles today and bilstein 5100s for the front. Ill be setting the 5100s at 0 and i already have a 2 1/4" block in the back... do yall think ill have bro lean, or be pretty close to level?

 

You should be pretty level with that setup. I would suggest a 2" AAL instead of a block though. Blocks cause many problems down the road, and an AAL only costs slightly more then the blocks.

 

Thanks man. I will most likely do that in a week or so after i see how how it sits once the spindles are on.

 

I have been waiting way to long. Although i dont have all the money for exactly what I want, I think Im going to do it in stages. Planning on ordering spindles, and 2 inch add a leaf for starters. Should be level right? Then in a year or so upgrading to 5100's and eibachs, plus all pro springs. I just want it lifted now!

 

If you just want the 4" in front and 2" in back (that will be level) then there is no point in swapping springs and switching to 5100 in the future. The first setup you're talking about will ride great.

 

thank you. No problems then fitting in 285's with that set up right? I know you have 35's, but are set higher. ( forgive me if I am wrong)

 

I had to cut my cab mounts at 5" and beat the pinch welds ...it rubbed pretty Damn bad.....but the other side didn't at all

 

Anthony when are you getting 35

 

U can fit them but u will rub, how tall are u going, I had terra grapplers that were 285/60/18 that didnt rub to bad but then I got trail grappler mt that are 285/65/18 and rubed like a mofo