60" Hi-Lift

Damn 15% off is if you spend $150+

4wheelparts.com is still cheaper if you use coupon code CC5OFF and have it delivered to the store.

 

They seem to change their deals like once a week, just wait and you can get 15% off of your first purchase.

 

Short bed version if this would be bad ass.

 

60" "xtreme" fits in my dcsb with tons of room. take the base off and remove that top attachment.

 

60 glorious inches it is! Is that what she said?

 

Yes it will fit if you are willing to use a rachet and box end wrench.
I removed the top piece 3/4" wrench and socket, removed the foot and it reinstalls with a push pin/or cotter pin.
Bolted it to a bracket on my Unistrut replacement rails with 3/4" size nuts.

So when you need it I have a 3/4" wrench that removes the 2 mounting bolts and then puts back the top piece all in one easy deal so you can have a full 60" jack.
I might have some pics somewhere.

 

I need them there pics

 

Homemade bed bar and 60” Hi lift

 

Homemade has always tasted better...

 

Yes it does.

 

HHMMM, been calling this a 60" jack since I bought it, might have to go measure it....... OK measured it, 59 inches to the top, used all of it the other nite getting unstuck in the sand trail doing stupid stuff. Of course it was raining hard.

 

Dude! You are awesome. Thanks for the pics. Where did you get the mounts from for the hi-lift? how much?

 

Every body sells them, got mine from 4 Wheel and off Road here in Orlando, like 40 bucks. I have used this jack so many times getting me and others unstuck. Jack the living piss out of it and shovel dirt under every tire that comes off the ground.

 

I noticed that you have to drill into the bed liner for these. Not diggin that...

 

The material to make this was less than the ATO mounts that I had before. ( its .120 wall 1.5" DOM)

I threw the base in one of the ammo cans to get them tight to the bed

you could mount the 60" in the same spot with no base or clamp attachment, but it would be really tight

Justin

 

I concur

 

you could also make your own. one of our florida guys just made these out of 1/4'' aluminum. bent it by hand in a vise and drilled holes for the bed rail hardware. all he has left to do is drill for the jack hardware itsself. conceptually, they are pretty much the same as the ATO ones. he said he's about $15 in for the project.

 

Found this yesterday in my search. And I think u guys convinced me to get the 60. I'm only gonna buy one why not get the best?

http://www.tacomaworld.com/forum/product-reviews/139239-hi-lift-jack-mounts-bed-2.html

 

What exactly are you referring to here?

 

The mounts and how he made them. If u can weld Thoes are simple to make that's what im gonna do when I buy mine.