What Have You Done To Your 2nd Gen Tacoma Today?

Where did you buy them?

 

We all know that V6 badge on the front grille gets all the chicks...

 

I tried, couldn't quite get it. I will mess with it again later

 

is he selling them again?!!!! ??

 

Finally welded my factory rear bump stops on to the u-bolt flip kit plate and installed my BORA spacers.

 

Performed my first oil change and installed a Tuffy Security Box in the bed of my DC. A pleasure to work on this truck!

 

Little video I made today with a fellow member AMG4LIFE

http://youtu.be/WaeK_HNJ5NQ

 

This............



Gentex 341 auto-dimming/homelink/maplight/compass/temp with amber display. No more need to do overhead console project for the reg cab now. Easy install. Love it.

 

I bought the clear version of those...I love em but they FOG BAD!!!!

I siliconed the shit out them and it worked on one but not the other.

I'm trying to figure that out now.

Hope you have better luck

 

Looks good man! Question for ya...when you install the roof rails, do you remove the roof rail molding or do the rails go over them? I am missing one of the roof rail moldings and was thinking of just going with the roof rails if they replaced the molding. Thanks!

 

I did the dome light/map light mod, the always hot 12 volt outlet mod and the fog lights any time hack. What next?

 

Built and installed a PVC oil catch can

 

Replaced my air freshener

 

Excercised my 4x4 on the way to work.

 

Gave it a much needed bath and cleaned out the interior.

 

gusher - I recently went with the roof rack rails on mine as my Tacoma was missing one of the moldings. You must remove the old rail molding to install the roof rack. Cheers and good luck!

 

I feel your pain...after a mud run the other night I was pressure washing my truck and noticed the bottom corner under the turn signal/DTRL's was fogging a little. But the next day it was gone. I used a silicone based bathtub sealant around the seal, but I guess it wasn't good enough.

The factory roof strips need to be removed in order to install the brackets and fasteners that hold the OEM roof rails in place.

 

yes they do! i had a set on my access cab and there was nonstop moisture.

 

Since I got my spindles and 5100's installed over the weekend my 265's looked a little funny so I decided to Dip my wheels and badges. I think it looks a little better blacked out until I can get new wheels and tires.