AC blower motor? Changed resistor and still nothing

06 tacoma 2.7L, no air on any speed, you can hear the compressor kick on n off, AC light turns on just nothing comes out of the vents. Just did the blower resistor swap and still nothing.
Blower motor itself Im guessing?

 

fuses are fine. was working fine then i got back in the truck and it stopped. over the months its done this several times but if you gave it a good smack itd get going again... but no such luck.

 

inadvertently knee'd the glovebox and it started blowing out again

 

Start simple, isthe wire connector to the fan on good? It's easy to get to from underneath the dash.

 

Happened to me where I had to hit it to work and finally took the motor out and cleaned the blower motor with MAF cleaner spray and haven't had a problem since.

 

thanks for the tip, i was JUST thinking if MAF spray would clean it.

 

Theirs a thread on fan speed not working stickied. Mine does it too I bought a new resistor and problem has stopped but I knoe the harness can get s burnt spot on the connecter not big enough wire for the power.

 

Thanks so much for this info! I tapped the motor near the shaft end with a small hammer & the blower started working again. At first it ran slow .. so with about a dozen light taps it finally got up to full speed.

 

Check and make sure the connector isn't burnt. Yea it's working now, but it could be that it's shorting out, and it could potentially cause a fire. Never hurts to be thorough.

 

I appreciate that ... thank you. The connector was the first thing I checked & cleaned. The motor may need to come out & be cleaned as someone else mentioned. But for now it is working just fine.