San Diego BS Thread.

Anyone interested in my Sportz brand truck bed tent?

It's not specifically made for our Trucks but it fits fine.

$50

Here is how it looked on the truck with my old airbedz which I no longer have.

 

I gotta take a shit...

 

sigh...kids...

 

Jelly cuz it takes ya older folks a few hours longer to muster up the strength and fiber??

 

Of course Leo, lemme know when you need stuff done, waaaaay cheaper than the dealer.

I got the RV all packed up. just need to round up a few things and were off to OW. Looks like we are going alone, everybody flaked out on me. Sheet, I need me some more expert riding buddies, looks like its time to enter a couple of races so I can meet some peeps again. Either way, nothing as fun as riding a dirtbike.

ANybody going to OW between tonight and next Tues?

 

no actually very regular, 500AM everyday and 2PM,never an issue, could set world time to my dumps...

 

Coming out to Superstition Greg? Long time no see.

 

Bumper looks awesome!!!

 

Gimme a call if you want to come out!
Test the GoPro

 

lol I don't know where I'm gonna be when I'm anywhere anymore (if that makes any sense.) As far as I know, I'm off roading through you guys until marriage is all squared away. If money is having it, I'll probably make a desert trip soon.

 

Thanks Matt, got some bad metal on metal qreeking going on and none of the usual suspects are panning out, may have to stop by the truck shop.

just got back from starbucks and a gopro3 try out, see how these vids turn out, so far you can hear it, its loud for sure.

 

Tell me about it. We just picked our date and location up in Paso Robles, I can see all my monies flying out the door as I type.

You should make it out for a day or 2! I'll sponsor a few gallons of petrol for your trip

Try the alum plates, I put rubber washers on the mounting bolts where it mounts to the tube and a lot of noise went away.

 

You're awesome, Matt. Thanks much for the offer!

 

Perhaps, I had the bumper on the truck for last weekend and no noise, alignment was off badly, then they finished the bumper, adding the winch mount and such lastweek and fixed the alignment then noticed the noise on the ride home but not bad at all just figured it was a dirty spring or uni-ball., as time and miles go on its getting worse, I hit all the bolts on the bumper as its bolt on, all the bolts on the from suspension, wondering if its the skids as they had them off during fab. sprayed everything with triflow like James suggested.

 

Question, 3 or 4ft CB antenna? Thanks

 

8ft. 2 of em. you're welcome.

 

You're the best, thanks!

 

^^^^^ This for sure, just be careful not to mount them too close to your stacks

 

Almost packed, we look like Gypsies!

I have a bike hauler on the front of the RV with my YZ250 on it, I have a dual bike carrier on the back with the CRF250x and the CRF450r, then I welded a receiver on the bike hauler and tow the Jeep from that....Oh boy that Chevy 454 is gonna be working hard, surprised the transmission is still working flawlessly after all the weight I have been pulling (knock on wood).

Gotta go to Cycle gear to get some more fuel, uh, I mean Utility jugs for some more go fast juice. All the bikes are full of fuel as is the Heep, so I think we are almost ready.

By tonight I will be roving through the hills, and tomorrow morning get to play on the bikes!

Maybe I will see some of you guys out there.

 

just get a 102'' whip, then a bumper to mount it to and figure out a way to tie the tip down when your'e not using it.