Feeler: 05+ Fabtech 6+2.5" lift kit

I haven't torn one yet in the 20k I've out on the truck since the lift. I'd recommend New uca's for alignment correction. Mine was so close to perfect alignment that I didn't bother and I had no issues.

The only problems I had were wheel bearings but you must understand that I was running 14" wide rims with wheel spacers... my fault

 

i had a serious problem with those on my 05' an i ran just a coil spacer and 33's..... they were right at 400 x4 of them thats something i dont wanna have another problem with lol

 

You replaced boots for $400? You can replace bother CV axles for $70 a piece.

 

Wanna sell the 35s?

 

that was to replace the hub bearings

 

Only if you want the rims that they are on as well, Gonna ask 1200 for those. They've been on the truck just a few weeks

oh yeah, bearings are costly if you don't do them yourself. I've done them a few times because of the width and offset of my previous wheels.

 

what is your rear suspension setup on this?

 

notice your running 5100's on your stage 1 what setting you at? and tire size if ya dont mind

 

how much for just the coil spacer kit?

 

rear setup is an add-a-leaf with a block, simplistic, and frowned upon by some people, but for a truck that i don't flex out on trails, its not an issue with the u-bolt flip and trac bars I built.

 

coils will go with the kit as a whole unless buyer states they dont want it

 

my haggling bartering and ability fab has my curret projection at 2k with built axles with 5:13 gears

 

trail pics taken off clearfield which is near Greenbriar/Kempsville

 

Do you still have the welds if so are they 4 sale?

 

I would be interested in your kit if you end up selling it!

 

Welds are gone, regrettably. If I had them back I'd never let them go again

 

What kind of welds were they

 

16.5x14 stone crushers

 

EDITED

 

Shit Aaron... that's right between us! WTF?