TacticalBacon13's camp

$375 to re tube and balance a drive shaft with new carrier bearing and joints

 

VVVVVV 5.5 Found receipt, new one isn't as old as I thought.

 

joe is still on his factory battery
and he said he just recently left his dome lights on for a few days and it still started right up

 

On my third Optima. I do not recommend. The redtop in the Tacoma took a crap after 9 mos, replaced with a yellow top under warranty. Jeep has a redtop, less than a year old, I am sure it will die soon.

Diehard Platinum, best unit you will find short of an Odyssey.

 

I thought I remember reading a while back that Optima got bought out and have turned to shit. And that Diehard Platinum is actually a rebranded Odyssey. I think that's why I went with the Platinum for my tailgating stuff.

 

i has to buy a battery for my car and looking to upgrade the one in the fj. so you guys really dont like your optimas?

 

Some of the guys on TOR said the same thing or something similar :can'tremember:

I got Duralast in mine. Good warranty and cheap prices. Before that I always ran Die Hard with no issues.

 

Cheaper than what I've found. I want it done before I go to moab

 

There is a place in brookville pa (can't think of their name) that does custom drive shafts if that would be of interest to youz guyz I can see what I can dig up as far as a name and number goes

 

dam i hear other guys south getting it all done for under $200
i am going to stop by with the driveshaft tomm and see if i can get a better price
for that price i will buy another stock ds and call it a day

they work great holding down the floor right
isnt your battery always dead anyway....

 

ME THINKS YOUR ELECTRICIAN HAS SOMETHING DRAWING POWER AT ALL TIMES...

 

Just had a buddy break on the trail 2 weekends ago. Turns out his Tom Woods had horrible weld penetration and failed at the U joint weld. Luckily for him all he had to do was grind off the old crap and throw a new bead on. I was not impressed at all. For the money you pay them that thing should be bullet proof. He's not even putting out 100hp in his Samari.

This....

Dude I drove my truck 4 times in 4 months and my truck started right up last night when I went to move it. Granted it sounded like it was going to explode.........

You has wire issues

 

SO DOES ANYONE HAVE A LOCATION ON THE SRS ECM IN OUR 2ND GENS?

 

OE driveshafts are .060

I can't even use .060 cladding at work because it's so thin. We use .080 minimum. Of course we are using aluminum and the DS is steel.

Main computer is under radio. No clue what a SRS ECM is

 

I AM GOING TO CHECK UNDER PASS SEAT AGAIN?
DID NOT SEE ANYTHING THERE LAST TIME BUT I WASNT PAYING ATTENTION THAT MUCH

 

wut you looking for? what years your turd? I have nothing under my pass seat except the air bag harness for the passenger

 

sch 10 or 40 here
tbd

 

09
trying to fix my truck srs and yaw rate no workie

 

water didnt get that high
so wtf