I'm not sure I know what I'm doing

Much better with the solenoid under the hood! Are you going to put a case or something over the exposed wire connections?

I just received a Roadless Gear inside winch mount and I'm hoping to get it installed in the next few weeks. Not sure if you've thought about doing this or not. My solenoid's under the hood as well, but I'm not sure if I want to have to pop the hood to use the winch, so I went ahead and ordered the inside cab switch. I can bring it out Sunday if you want to have a look at it.

http://www.roadlessgear.com/Jeep/p/1865/dash-mounted-winch-control

 

I'm going to mount a on/off switch and a three pole momentary contact toggle in my centre console by the seat heater switches, same as your setup just a little more homemade, if you need a hand installing it let me know, I'm always up for a garage night

 

I would have cut that tree down for what it did... learn a lesson!

 

If that tree wasn't there the trail wouldn't be a challenge, what's a off road park without a challenge?

 

Nice work!

Love the custom fabrications

 

Thanks man, more coming in the next few weeks

 

Love the pics and the self-fabrication of parts.. I'm jelly good work though

 

Sunday fun

 

sunday is always fun day.

 

Wow! Snow sure melted a lot in a month! How'd the Raptor do?

 

Good looking truck. Very jealous of your fabrication skills.

 

You sir have built some pretty impressive looking stuff! Sick truck!

 

The raptor made it look easy

 

Time for a new project

 

Sliders!

 

You bet, doubt they'll be ready for Sunday, maybe next Sunday... I'm going to post fabrication pics in my bumper build thread, when there done ill post a few pics here

 

Thanks guys, I started fabricating because I couldn't afford to buy it, and as long as it functioned and I was happy with it I didn't care what it looked like but it feels damn good to get approval from truck guys that know what go into it

 

I wasn't stuck here, plowed through a lot of this today



Here I'm stuck

 

Can you show how you ran the wires in to the cabin?