What have you done to your Tacoma today? 1st Gen Edition

Drove it around looking for somewhere to fully flex the rear, still nothing... Haha

 

Trim this down and you got yourself a sigpic!

 

Haha yeah, I planned on it I just haven't done it yet.

EDIT* Done

 

Very nice! What did you do for your rear lift again?

 

Just a 2" Pro Comp add-a-leaf and Bilsteing 5100's. It's about a 1/2" lower in the rear, but it's not noticeable. Once the front coils loosen up I should sit about level.

 

Oh ok. You're looking just a tad ass high in your signature picture.. But I'm thinking about rebuilding my packs for lift rather than aal's or dropping some coin on new packs. Def going with bilstein/eibach for the front though

 

Hmm, yeah that pic does make it look higher in the rear... But this one shows it better...


Yeah, if you can rebuild your packs then awesome. Even with my aal mine look flat to me. But I plan on getting AllPro leafs eventually, the aal was just to get it lifted for now.

 

I checked but didn't notice if you posted your new fender heights after your lift. I was just wondering what they were? Also what size of tires are you running? The new lift looks nice!!

 

Found out my wheel bearing is almost gone... drove about 2000 miles on it and it hasnt fallen off yet new ones on the way though

 

Satoshi'd my deal

 

Stock Tire to fender:
Driver Front - 5.75"
Driver Rear - 6.5"
Passenger Front - 5.75"
Passenger Rear - 7"

Lifted Tire to Fender:
Driver Front - 9.25"
Driver Rear - 8.75"
Passenger Front - 9.5"
Passenger Rear - 8.75"

Overall I got about 3.5" of lift in the front, and 2.25" of lift in the back.

The tires are stock 265/70/16's, I plan to get some 33x12.50x15 KM2's

 

Measurements are usually taken from hub center to fender.

 

Will get better pictures this week. I am really happy with how it came out but the grill came with a little warp in it which causes one cornet to stick out a small amount.

 

what lights are those, I swear my stock ones are dim as fawkkk.

 

Changed out the fuel filter.

 

I meant to put tire to fender anyways haha

 

I did a retrofit with mine. Pretty simple

 

Got my sparkplugs/wires in...and the ebay seller I bought the kit off of sent the wrong spark plugs.

They are the BKR5E and the truck calls for a BKR5EYA. (NGK)

But the new NGK wires look good

 

edit: nvm... should have read on

 

so i tore apart my interior today and i am very glad i did found a few things that the OP left behind



wires from a previous stereo install



took me about 4 hours to take everything out (seats center console dash) and completely clean it out and put it all back together pretty simple and i found a total of 13$!!! 3$in change and a 10$ bill stuffed up under the carpet