Idaho BS thread in the PNW

Oh then yea that would be a good call.


Also...don't go rent a cheap ass compressor again for these haha go t a tire shop and have them do it. 620lb coils man..

 

Good hell.. You guys must be light, unless it is a difference in the shocks, cuz 2nd gens run the exact same eibach coils and we only get 1.6" out of them without a bumper.

Speaking of light. I got to use my hi-lift to help reset a coil on the Wrangler saturday, he over flexed the wheel and it popped out. It was so easy to jack the front end of that Jeep up. When I used my hi-lift to do the cv on my taco it was getting to be a workout to push the jack handle down.

 

How does that much lift affect your cv's monte? Do you have much vibration while driving?

 

I put my 656 lb coils on with cheap ass spring compressors

Scary as fuck! The spring compressors were started to bend...

 

Much lighter. Smaller motor and tranny.

Cvs..don't love it haha I have two blow boots. No vibes at all though. I have been told the older 95-97s take the 3"+ better then new tacomas.

 

Exactly..

But your are 656??

 

ill be doing it with andy...he has real tools and knows what he is doing, will be far less of a derp fest....however he fits the derp mold pretty dam well so you never know

1st gen are superior!

i think his boot is torn...which does not give me much hope

shit, the rods on the shitty spring compressor i rented started to bend with my stock coils! Fuck that with 656s!

 

Give me back my pulled pork asshole!

 

So I threw the summer tires back on the truck today...kinda sad. Doesnt look near as mean lol

 

hey. go the fuck to bed. Its too late for you.

 

http://www.tacomaworld.com/forum/1s...upercharger-urd-7th-injector.html#post6574596

ARGHHH

 

I like my eibachs

 

Do et!!!!!!

 

Yeah, the 886's are about a 656 lb spring rate.

http://www.cruiseroutfitters.com/tech_OME_coils.html

Says they are a 115 N/mm rate in that link, which converts to just over 656 lb/in.

 

660

 

I waved as you flew over. Did you see me?

You need to get out more.

 

I live in Idaho. Who cares abut CA? haha Just a big group of hippies there for the most part.

 

Yes there is.

 

Mark, if there is any doubt about those coils, they should be marked with length, ID, and lb/in information. Here is what is on my eibachs. It is 14" long with a 2.5" ID and 650 lbs/inch.

 

Yours aren't toytech eibachs tho Mike yours are different.