1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

tried to change oil today but...

Discussion in 'Technical Chat' started by fireturk41, Jun 7, 2009.

  1. Jun 7, 2009 at 5:14 PM
    #1
    fireturk41

    fireturk41 [OP] I like to break shit!

    Joined:
    Dec 23, 2008
    Member:
    #11857
    Messages:
    4,840
    Gender:
    Male
    First Name:
    Kevin
    High Point, NC
    Vehicle:
    280k miles
    SAS, Locked front rear, Ufab sliders and bumpers, air compressor, 35" BFG KM2 on steelies and 36" TSLs
    it seemed like the drain plug was torqued on there! i usually ratchet it an ounce above hand tight but i tried to take it off and it felt like i was gonna rip out the oil pan before the drain bolt. do they sometime torque on because of pressure? ive never had this happen and should i break out the torque wrench tomorrow?


    also anyone know any good exhaust shops near greenville nc, my check engine light came on and the obd reader narrowed it down to the exhaust/fuel system
     
  2. Jun 7, 2009 at 5:15 PM
    #2
    DanGer

    DanGer Avatar approved by 98tacomav6

    Joined:
    Jun 7, 2008
    Member:
    #7155
    Messages:
    5,480
    Gender:
    Male
    Northern Virginia & Blacksburg
    Vehicle:
    07 Base 4Cyl 4x4 Manual
    White Head Light mod, White shorty antennae, Doug Thorley Long Tube headers, AFE Drop in air filter, Secondary Air Filter Removed,
    I used a breaker bar on my first one...
     
  3. Jun 7, 2009 at 5:16 PM
    #3
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,530
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    Tap the wrench with a hammer, and see if that helps. The plug should only be about 30 lb-ft.
     
  4. Jun 7, 2009 at 5:47 PM
    #4
    tacomaman06

    tacomaman06 Carolina Alliance: Enforcer

    Joined:
    May 1, 2007
    Member:
    #1475
    Messages:
    26,212
    Gender:
    Male
    First Name:
    Will
    York,South Carolina
    Vehicle:
    '16 Tundra TRD Pro
    getting there....
    oil plug should come off fairly easily. also....for the cel.....try tightening the fuel cap a few clicks and reset the light...see if thats the problem.
     
  5. Jun 7, 2009 at 6:09 PM
    #5
    fireturk41

    fireturk41 [OP] I like to break shit!

    Joined:
    Dec 23, 2008
    Member:
    #11857
    Messages:
    4,840
    Gender:
    Male
    First Name:
    Kevin
    High Point, NC
    Vehicle:
    280k miles
    SAS, Locked front rear, Ufab sliders and bumpers, air compressor, 35" BFG KM2 on steelies and 36" TSLs
    did give it a shot to no avail
     
  6. Jun 7, 2009 at 6:15 PM
    #6
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,530
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    Post the code that was given.
     
  7. Jun 7, 2009 at 6:16 PM
    #7
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,724
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    x2
     
  8. Jun 7, 2009 at 6:18 PM
    #8
    fireturk41

    fireturk41 [OP] I like to break shit!

    Joined:
    Dec 23, 2008
    Member:
    #11857
    Messages:
    4,840
    Gender:
    Male
    First Name:
    Kevin
    High Point, NC
    Vehicle:
    280k miles
    SAS, Locked front rear, Ufab sliders and bumpers, air compressor, 35" BFG KM2 on steelies and 36" TSLs
  9. Jun 7, 2009 at 6:18 PM
    #9
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,530
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    Check for exhaust leaks at the manifold, pipes, catalytic converter. Repair as required.
    Use a scope to diagnose the oxygen sensor operation (Tip: The oxygen sensor in front of the catalytic converter normally has a fluctuating waveform. The waveform of the sensor behind the converter should be more steady).
    Inspect the downstream heated oxygen sensor (HO2), replace if necessary
    Replace the catalytic converter
     
  10. Jul 19, 2009 at 7:07 PM
    #10
    mpgnc64

    mpgnc64 Well-Known Member

    Joined:
    Jul 28, 2008
    Member:
    #8180
    Messages:
    262
    Gender:
    Male
    First Name:
    Mike and Denise
    Western NC
    Vehicle:
    06 4x4 Access cab 4cyl 5spd, 2000 Prerunner
    Tool box, Thule rack, rod holders, 5100s at 1.75 and the TSB
    Bob's Muffler in Goldsboro does great work.
     
  11. Dec 11, 2009 at 7:01 PM
    #11
    themaine1

    themaine1 Member

    Joined:
    Oct 16, 2009
    Member:
    #24394
    Messages:
    16
    Gender:
    Male
    South Carolina
    Vehicle:
    00 TOY
    alarm, speaker upgrades
    What was the outcome?? I am having what sounds like the same problem...Noise from under the truck, but chasing down a "EGR Vaccuum Problem" with no good results. I have a cracked manifold and am trying to find a "good" fix for that which may fix my PO420...Sounds like a plan to me! BTW 2000 Taco regular cab with 319K miles!!!!
     
  12. Dec 11, 2009 at 7:03 PM
    #12
    98tacoma27

    98tacoma27 is going full "SANDWICH" Moderator

    Joined:
    Dec 18, 2008
    Member:
    #11714
    Messages:
    67,724
    Gender:
    Male
    First Name:
    Ben
    Not Beech Creek
    Vehicle:
    05 Tundra SR5 (+295k AND COUNTING), 2006 F350 King Ranch 6.0L
    Some stuff. Not a lot, just some.
    Your cracked manifold may be the cause of your egr issue.
     
  13. Dec 11, 2009 at 7:10 PM
    #13
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,530
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    X2.
     

Products Discussed in

To Top