Exhaust Reroute pics

Can i get some Exhaust Reroute pics? i want to do mine and i want to see how everyone is doin theres, and how much did it cost?

i scraped doin some crawling today and put a small dent in the pipe that hangs lower than the frame

its the pipe that is right nex to the trans, its the lowest pipe in the truck
Thanks!

 

Subbed

 

^^^ sorry man, not that pipe, its towards the front, right before the two pipes join into one, it comes from the drivers side to passenger

 

I think OP is talking about where the exhaust drops down near the front frame crossmember -- it's the first relatively fragile thing that would hit on a rocky protrusion, and is IMO kind of dumb design for a truck that is marketed for off road use. I have been thinking of ways to do a reroute for a while, so I'm also interested in any pics that people may have.

 

im trying to find links.. anyone have any links?

 

I got a Wicked Flow muffler from the group buy, it's still active, for $70 or so shipped. It's a dual 2 1/4" or 2 1/2", 3" single, 13". Install should cost us around $100 to $200.

 

Someone else chime in but doesn't the URD y-pipe raise the section of the pipe that the OP is trying to relocate?

 

I had mine redone when some jerk cut the cats out from under my truck, I was not there when he did the crossover and he put it up close to the transfer case actuator so I ended up making a heat shield

 

Tacoma exhaust crossover pipe reroute

Finally got this done and done right. 409 stainless TIG welded.


Untitled by mspr11, on Flickr

 

Where in CO did you get it done at?

 

Hanksville hot rods in Littleton. These guys are top notch.

 

This is how mine turned out:

 

so are all these re routs loosing the rear cats?

 

Hmmm cool, may have to hit them up. How much did they charge?

 

Nop, the reroute on mine was done only for the driver side (the one that crosses) on the passenger, they just added some tube to fit the y pipe... And was done just after the cat (you can see it in one pic)

 

Mine probably looks like everyone else's....

 

Got it done at speedy mufler in hayward. Got the wrap and reroute done for 220

 

This is mine lol. I welded a cheap turn down tip after the video.

https://www.youtube.com/watch?v=7FQdRKMbCSg

 

I got these from another thread - 2017 reroute, but I can’t find the link either:

 

Old thread, but I figured I'd contribute what I've done.