WhyNotFab's Zombie Assault Vehicle..

My bumper looks like crap haha.. has paint flaking off and rust spots need to have it Rhino Lined or LineX'd unless you guys have any suggestions on a similar coating I could do myself for way cheaper..

 

Can you tell me more about the AK you have? Looking into buying one, looking at the Century arms c39 tactical AK in the 7.62.
Also are you the owner of whynotfab?? I was just checking it out and the forum and everything, id love to run the decals!!

 

OP, Did you paint your frame or is it the factory finish?

 

Finally got the All-Pro rear bumper with side plates, took the front off and grinded it down to spray them both with Raptor Liner I got off eBay, spraying the nFab steps when I get the All-Pro skid plate.. I think they turned out nice, mounting them back onto the truck tomorrow.

 

Hooked up my train horns last weekend too, horns are in the front bumper, two on each side facing out the holes on the sides of the winch, and I'm going to mount an air hookup somewhere under the rear of the truck and maybe one at the front for airing up tires/tubes/blowing dirt out of stuff.

 

WeatherTech front liners came in today, may get the rear soon even though no one ever rides in the back lol

Front Bumper installed, waiting for help to put the rear on,

 

Rear came in,

 

Fabtech 6" lift, 35" Nitto Trail Grapplers, & stainless brake lines on the way!

 

Yea budday!
nice work on the AP bumper



be sure to post up when its fin

http://www.tacomaworld.com/forum/suspension/43093-fabtech-procomp-6-lift-more-pictures.html

 

I picked up a couple cans of spray on Bed liner by duplicolor & I love it. The black kind is tough & looks like powdercoat. Just take your time & spray as many light coats as you can. It cakes up pretty easy

 

Picked up some oil for the differentials & transfer case this weekend.. need two more bottles.. & my EBC rotors showed up, still waiting on the green stuff pads, and JP has my stainless lines arriving tomorrow, hoping the lines/rotors/pads will help stop the 35s a little quicker.

 

My step dad supervising lol,







Got the front done, I'll take pictures of tires mounted once it's all done.. put the EBC rotors & pads on, along with the stainless extended lines from JP which worked great.

Not re-installing the sway bar to see how that rides, also since it looks stupid hanging that far below the bumper.. so I'm going to ditch those angled sway bar drop brackets & make new straight plates for the reservoirs & try to raise them a little more. They happened to work right there with those brackets so for the time being it's fine and the tires have several inches of clearance from them at full lock..

Ran into a few small issues, and took breaks.. no hurry.. so the front took all day lol. Heading back over to my step dad's shop to start on the rear soon. Once the rear's done we're changing the oil in both differentials & transfer case, & cranking the coilovers just a little if needed to match the front fender to ground height to the rear.

More pics soon!

 

Picture of it now vs. the day I drove it home..

 

Installed my Ultragauge today.. still need to fine tune the calibrations, mounted it in the upper left hand corner of windshield.. I'll post a picture soon. Ordered the Quick Lift hood struts & tailgate EZ down.

 

looks awesome!