New England B.S. Thread

I'm talking about playing along to it.

I always seem to lose my voice when I listen to Metallica while driving...

 

Cute. Hate cats but cute

 

Beats the hell out of renting.

 

My woman did this and it helped her when she went to buy. A little extra knowledge never hurt.

 

anyone else here looking hard at the intake manifold spacer? 215 bucks, not sure you could go wrong...

 

welcome to the site. Debadging is very easy. Like billy said alot of guys use fishing line. I used fishing line and a hair dryer, warmed up the badge to help the fishing line slice through the adhesive. Slide the line behind the badge and use a sawing motion. You should be able to get it off with no damage to the paint, then use goo gone to get the rest of the adhesive off.

 

Yours? The girlfriends? Or both? I have always liked cats.

 

The light bar I have is an NFab bar. My fiance bought it off Amazon a couple years ago for just over $100. The powder coat that comes on it is thin, I coated mine with bedliner.

For tint, I used a place in Billerica. I'll try to find the name, but they're a chain and did a nice job.

It's getting easier these days... No more retrofits

Rates are awesome now! I bought a couple years ago and alreay refinanced because the rates just kept dropping.

Pretty much this. Get a good lawyer and you're all set.

I am but I won't jump until I see what it does below 3k RPM. Plus, I'm intrigued by the guy who made the spacer from a cut up manifold!

 

haaa, i wont say i havent looked into that method myself

 

My only fear is you have to have the top perfectly smooth where you cut. I'm not sure if a belt sander would do it or not. If I can find an old manifold, I'd give it a shot!

 

ill bet you could go to a machine shop and have one made for cheap money.

 

You mean have a spacer made or mill down the top of an existing manifold? I need to find someone in a college tech major with access to a CNC machine

 

Excellent advice and I will try that tonight. As a avid fisherman, I have the tools I need to do this job no problem. Thank you!

Now to go shopping for that light bar!

 

I'd complain if I paid. My women does so I'm not bitching

 

Both. She picked him out and named him Mister. I refuse to call him that so I call him yota she gets so pissed.

 

I was but got sick of the bullshit excuses. I did check on it again and saw one guy take a stock intake and cut it down for a spacer

 

Start calling him Mr. Yota

 

Oops should have read further. I bet you could get the plastic intake close on a belt sander. We had a straight piece of steel that we used to use, attach sand paper and just run it back and forth

 

Slayer does it to me..usually "The Antichrist"

 

Awww..love that cat Dave!