Tacoma Lift? 2012 DC V6

I forgot to take measurements before I installed a 1 1/2" Toytec AAL TSB, 5100 Bilsteins all around with Eibach springs in front, how much of a lift do I have approximately or should I have? Thanks to everyone.

 

The billies are set to zero with the Eibachs ?

 

I was told by Toytec that .85 was the max i could go on the billies with eibachs so I went with their advice.

 

I would say 2" average for the Eibach and Billies at .85 would put ya right around 3" in the front. Pictures would be nice too
Do you have new UCA's? Did you have an alignment done?

 

So they are at .85 ?

 

1.6 + .85 = 2.45

 

True to spec but I've heard others getting close to 2-2.5" with the springs unless running a plate bumper and skids?

 

No, no new UCA's, alignment were within specs whatever they were, the eibachs are 1.6" according to Toytec and the Billies set at .85 would add up to 2.45," right? As far as pictures go I'm too dumb and don't know how to post pictures, yet, lol. I'll try though. I think that's the lift, but I'm not sure, that's why I asked. Talked to a Toytec rep and was told that with eibach springs, the Billies should not exceed the .85 setting, that should be the max setting as I mentioned in an earlier post. Thanks to everyone for all the helpful comments on my post, appreciate it.