For Sale: Bed divider

I have a bed divider I'm trying to sell. It came with the truck when I bought it and I never use it. I'm trying to scrape up some money for some mods for my motorcycle. Here's a pic I found online, but I can upload an actual of my divider if needed. It is in excellent condition and comes with all of the hardware. I'm looking at $200 shipped in CON US.

 

dang it!!!i wish i had extra money.

 

wow, i have never seen that. I like!

hmmm

 

That's exactly why I'm selling it.

 

i'll give you 120 for it and pick it up friday...i can swing thru on the way to myrtle beach

 

I was planning on making $180 after shipping. That's as low as I'll go. I don't have to sell it.

 

probably so...but you never know how bad someone needs the money, straight up quick cash talks. Thats how you wheel and deal. The first rule of negotiation..if your arn't embarrassed of your first offer...it was too high.

 

I understand. I wasn't offended by your offer. Besides, for $60 more than your first offer you're still getting a good deal.

 

Just curious, what is the width of the slider clamp (how much rail does the clamp take up). would like one, but my canopy mounts will limit the positions. Thanks Sir!

 

Is it metal or all plastic?

 

You could mount some off-road lights behind it facing rearward, and it would be like those guys who have the lights mounted behind their grill...... cool.......

 

The divider is metal and the rail connectors are molded plastic.

 

The clamps are 8 inches long, so they will take up 8" of each side.

 

I have seen these turned upside down and used to haul ladders over the roof and what not. They push them up near the cab and they kind of work like a headache rack.

Marc M

 

This is something I want to add to my bed. With a standard cab I use the bed a lot and one of these would be sweet to keep things from going all over the bed.

aaaaaaaahhhhhhhhhhh...too many mods/things to get. Seems like they always show up when you least expect it or not ready for it.

 

One more question. Do they mount just like the tie-downs (spring with rotating flange bolt) or do they have to mount by sliding from the rear end of rail only.

Thanks again.

 

Mount by sliding the 8" section through the rail.

 

OK - in other words it must mount only at tailgate end of rails by sliding on and all rails must have no obstructions to adjust to desired position?

If that is the case, my canopy rail mounts will be in the way and must be removed to mount the bed divider at any position?

Just want to make sure I understand. Thanks!

 

I can't remember, but I think that there is a square block with a threaded hole that actually rides inside the rail and the 8" peice has a long notch that slides along the channel of the rail. You can actually flip the clamps 360 degrees when you loosen the hand tightened bolt. This also means that you can insert them at both the cab and tail gate ends of the rail. I hope this makes sense for you.

 

Thanks alot for clarifying. Yes it makes sense - need to look things over.