Question about Motive Brake Bleeders

I have read about the Motive products as being touted as a one person job - is that so? Also, from what I have read it is a pressurized system - how does that affect the ABS? My fear would be the pressure build-up causing problems with the ABS. Does the key have to in the "on" position like when normal bleeding, or is it fine with no power supplied? Thanks in advance!

 

Yes it is a one person job. I haven't had any issues with the ABS when I've used it. And I just bled it with the power off.

The ABS module has fluid in it, so if you don't fuss with it it should not trap air.

 

the motive bleeder is a must have for any garage. keep the reservoir topped off, i use my bleeder dry. these things are awesome. ive had mine for a little over 10 years now and use it all the time.

 

Thanks! I have been reading a lot of mixed - but mostly good - reviews on the Motive bleeders. It appears that they don't make one for the Tacoma and we have to use an adapter or the like just for our trucks. I have read quite a few reviews stating that the tops do not seal well and may be able to hold only 5 or so psi without leaking - have any of you had this issue? Also, what one is the best for our truck?

 

What is the preferred sequence for bleeding out trucks ? Mine is a 2.7 if that makes any difference. I heard start at rear right - the furthest form the master cylinder and I've head start at the left front - closest to the master cylinder. Thanks.

 

I've had mostly good luck with mine. It is maybe 3-4 years old.
Did 3 or 4 trucks, put it away for a while and the hose deteriorated some, so replaced the hose.
Also the gauge doesn't work now, so it needs replaced.

Start at furthest from reservoir, so passenger rear, then driver rear, then passenger front, lastly driver front.

 

That's the traditional way I believe. Thanks.

 

I have one of the early Motive Bleeders, and it is the universal type. You do have to work a little bit to get the chain that is provided to tie down the mounting flange to the top of the brake reservoir. If you do mount it evenly and tight enough, you can run the pressure on up to 50 lbs/ sq in. or more. I use the Motive bleeder on My Miata also. It is a good investment if you can not find a friend who will help you bleed the brakes. Good Luck

 

I just wanted to point out a problem with the bleeder. As you know, brake fluid is corrosive stuff. Today, I replaced the MC and had pressurized the bleeder to start bleeding the brakes. The hose split and sprayed the front of the truck (and me when I tried to stop the flow).

I try to get it clean after each use. But I guess it's bound to leak at some point.

 

I use clear vinyl tubing and an old milk jug. One person job for me. Did it yesterday after installing steel braided brake lines.