What Have You Done To Your 2nd Gen Tacoma Today?

Nice work. its a little late now but we actually have stake pockets under our top rail plastic cover that I would suppose u could have mounted that in. what is it mounted to? never mind I see now in if pic its in the rail system

 

Had to work half day, but got the front and rear on.

How to install a front plate bumper alone?
Rigging

Of course I'm never really alone. My 9yo girl always wants to help

I didn't install the skid yet because she is still using it to watch TV...

Pelfreybilt stuff is awesome

 

She's probly helping 'cause it's gonna be her truck in 7 years, and wants to make sure it's done right the first time

 

lol how do you watch TV with a skid? and X2 on the pelfrey stuff! My skids have been awesome!

 

Pulled all wheels to check torque on my spacers. While I had them off, checked all the suspension components I installed a few months ago to make sure everything was good. Then bought a t55 Torx to tighten the bed bolts, and ended the day with a wash.

Oil change light is on, so I'll have to take care of that in a day or two.

 

I installed a 1000w Power inverter now trying to find a good looking 120v switch that i can use to mount on the dash.. any help would be nice

 

Yes pulling shit out is the best

 

Scratch that, saw your post in the pelfrey thread

 

You're fortunate to have such a great helper. Your truck looks great!

 

My eldest would do this stuff with me too.... I've got a pic of her hanging out under my 4Runner, turning wrenches...

 

Installed LED dome light, TRD struts and springs picked up from GTAburnout (Hunter), Pioneer AVH-X4500BT white plasti dip the trim and Hretz DSK 165 component set with upgraded crossovers

 

any tips/tricks on how to remove the three plastic anchors that hold the rear mudflaps on 2013 Tacoma? I removed one, but it seemed to be too much brute force (almost ruining the plastic fastener)... is there a more proper technique? or, are those pieces actually one-and-done, intended to be destroyed upon removal, and do i need to have replacements at the ready?

https://dl.dropboxusercontent.com/u/63414790/rearmudflapRemoval.JPG

 

There is a tool that I used for popping door panel clips that did the job. Although they call them suicide clips for a reason. Its not uncommon that they break

 

I sent you a pm about this.

 

Yanked a shrub at 3am.now front yard looks terrible....ooooops.

 

Use a small/sharp screwdriver or knife blade to pop out the center part, then pull out the entire piece. This worked on 4 of the 6 that I removed. The other two committed suicide...

 

Some unhappy neighbors

 

Good call

 

Looks like the shrub won. Wait! What the hell were you doing yard work at 3 am? Were you loaded? No matter how sober you were, the tree one.

Shrub 1 / You 0